Lucent Technologies GW-DS300N manual Basic Installation & Configuration

Page 36

Show Password

If you want to let the system shows the password

2

 

you set, you can enable this check box. After that,

 

 

 

the asterisk(*) will be replaced by the showing the

 

 

password.

 

OK

Click this button and the utility will save the settings

 

 

and close the page.

 

Cancel

Click“Cancel”will exit the page and won't save

 

 

the settings.

 

Apply

Click“Apply”to enable the settings you made on

 

 

this page.

 

31

Chapter 2 Basic Installation & Configuration

Image 36
Contents Page IEEE802.11n Wireless PCIBus Adapter Foreword FCC Certifications Contents Advanced Configuration Introduction to GW-DS300N Package Contents FeaturesProduct Functions 2Basic Installation & Configuration How to install the driver and utility Basic Installation & Configuration GW-DS300N Basic Installation & Configuration How to make a wireless connection Basic Installation & Configuration GW-DS300N Authentication and Security Click on the Authentication GW-DS300N Basic Installation & Configuration GW-DS300N Site Survey Launch Config Utilties Use Zero Configuration as Configuration utilitySwitch to AP Mode ExitItems Descriptions ClickConnectUnknown,WPA-PSK,WPA2-PSK,WPA Ad-hocandInfrastructureProÀle Items Descriptions Configuration PSM Power Saving Mode When GW-DS300NBasic Installation & Configuration GW-DS300N Basic Installation & Configuration Authentication and Security Basic Installation & Configuration As the settings of the destination There are seven authentication types underInfrastructure mode Basic Installation & Configuration WEP Key Basic Installation & Configuration 6 802.1x Setting Reauthentication, Roaming, SameSsidand Always CA Server Basic Installation & Configuration GW-DS300N Link Status GW-DS300N Statistics Items Descriptions Transmit StatisticsReceive Statistics Buttons 3Advanced Configuration3 Auto-Based on the status of the network Advanced Configuration GW-DS300N QoS Not sit idle waiting for input that may never come WPS ConÀguration Start PBCGW-DS300N II. Start PIN GW-DS300N Advanced Configuration About Advanced Configuration Soft AP Mode How to use AP modeConÀg Wireless Mode Scroll down the list to choose the wireless Only and 802.11 B/G/N mix.Shown in the4.3. Security Setting Short Slot GW-DS300N Security Setting ItemsDescriptions AuthenticationGW-DS300N Soft AP Mode Access Control Disable ,Allow All , andReject All . The defaultSoft AP Mode MAC Table AIDSoft AP Mode Event Log Soft AP Mode Frames Transmitted Successfully After Retry Buttons Utility and Driver. Eeprom Electrically Soft AP Mode