Lucent Technologies GW-DS300N manual Shown in the4.3. Security Setting

		Off: Always send frame without protection.
	Beacon(ms)	The time between two beacons. System default is
		100 ms.
4
	TX Power	Please manually choose the transmitting power for
		GW-DS300N.There are“100% 75% 50%
		25% and Lowest”. The system default is 100%
		which means GW-DS300N has the maximum TX
		Power on wireless network.

Idle time(60 - 3600)(s Idle Timeout means a period of idle time before you go offline. Enter a maximum period of time (seconds) to define the maximum idle time. If the idle time is above the defined maximum idle

	TX Rate	There are several options including Auto/1/2/5.5/11/
		6/9/12/18/24/36/48/54Mbps for you to select. When
		“Auto”is selected, the device will choose the most
		suitable transmission rate automatically. The higher
		data rate you designated in the network, the shorter
		distance is allowed between the adapter and the AP.
		When the wireless mode is“802.11 B only”, the
		maximum data rate is 11Mbps (11b) so that there are
		only “Auto/1/2/5.5/11Mbps” options you can select.
	Channel	Scroll down the list to choose a channel for the AP.
		The default setting is channel 1.
	Security Setting	Click this button and then to set up the authentication
		and security of the AP. The detailed configuration is
		shown in the“4.3. Security Setting”.
58
	GW-DS300N