Lucent Technologies GW-DS300N manual FCC Certifications

Page 4

FCC Certifications

This Equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications.

Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at his/her own expense.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received; including interference that may cause undesired operation.

CE Mark Warning

Trademarks:

All trade names and trademarks are the properties of their respective companies. Copyright © 2007 All Rights Reserved.

Image 4
Contents Page IEEE802.11n Wireless PCIBus Adapter Foreword FCC Certifications Contents Advanced Configuration Introduction to GW-DS300N Package Contents FeaturesProduct Functions 2Basic Installation & Configuration How to install the driver and utility Basic Installation & Configuration GW-DS300N Basic Installation & Configuration How to make a wireless connection Basic Installation & Configuration GW-DS300N Authentication and Security Click on the Authentication GW-DS300N Basic Installation & Configuration GW-DS300N Site Survey Launch Config Utilties Use Zero Configuration as Configuration utilitySwitch to AP Mode ExitItems Descriptions ClickConnectUnknown,WPA-PSK,WPA2-PSK,WPA Ad-hocandInfrastructureProÀle Items Descriptions Configuration PSM Power Saving Mode When GW-DS300NBasic Installation & Configuration GW-DS300N Basic Installation & Configuration Authentication and Security Basic Installation & Configuration There are seven authentication types under As the settings of the destinationInfrastructure mode Basic Installation & Configuration WEP Key Basic Installation & Configuration 6 802.1x Setting Reauthentication, Roaming, SameSsidand Always CA Server Basic Installation & Configuration GW-DS300N Link Status GW-DS300N Items Descriptions Transmit Statistics StatisticsReceive Statistics Buttons 3Advanced Configuration3 Auto-Based on the status of the network Advanced Configuration GW-DS300N QoS Not sit idle waiting for input that may never come WPS ConÀguration Start PBCGW-DS300N II. Start PIN GW-DS300N Advanced Configuration About Advanced Configuration Soft AP Mode How to use AP modeConÀg Wireless Mode Scroll down the list to choose the wireless Only and 802.11 B/G/N mix.Shown in the4.3. Security Setting Short Slot GW-DS300N Security Setting ItemsDescriptions AuthenticationGW-DS300N Soft AP Mode Access Control Disable ,Allow All , andReject All . The defaultSoft AP Mode MAC Table AIDSoft AP Mode Event Log Soft AP Mode Frames Transmitted Successfully After Retry Buttons Utility and Driver. Eeprom Electrically Soft AP Mode