Lucent Technologies GW-DS300N manual Short Slot

Page 63

Not forwarding

If enable this function, though the wireless clients

among wireless

are connecting to the same AP, still they cannot share

clients

information with each other. The system default is

 

not forwarding data between stations.

 

 

4

Hide SSID

If the check box of“Hide SSID”is enabled, the AP

 

 

 

will not appear in the list of all the other wireless

 

adapters. It means only the wireless adapters

 

which has the same SSID can connect to the AP. In

 

this way, it can avoid the AP being connected by

 

unauthorized users. The default setting is disabled.

Allow BW40 MHz

When using “802.11B/G/N mix” mode, you may

 

choose this function to allow BW40 MHz capability.

Default

Click this button and the AP will show the default

 

value of this page. (Without Tx BURST, and Use

 

Short Slot)

Apply

Click“Apply”to enable the settings you made on

 

this page.

OK

Click“OK”button and the utility will save the

 

settings and close the page.

59

Chapter 4 Soft AP Mode

Image 63
Contents Page IEEE802.11n Wireless PCIBus Adapter Foreword FCC Certifications Contents Advanced Configuration Introduction to GW-DS300N Features Package ContentsProduct Functions 2Basic Installation & Configuration How to install the driver and utility Basic Installation & Configuration GW-DS300N Basic Installation & Configuration How to make a wireless connection Basic Installation & Configuration GW-DS300N Authentication and Security Click on the Authentication GW-DS300N Basic Installation & Configuration GW-DS300N Site Survey Exit Launch Config UtiltiesUse Zero Configuration as Configuration utility Switch to AP ModeClickConnect Items DescriptionsAd-hocandInfrastructure Unknown,WPA-PSK,WPA2-PSK,WPAProÀle PSM Power Saving Mode When GW-DS300N Items Descriptions ConfigurationBasic Installation & Configuration GW-DS300N Basic Installation & Configuration Authentication and Security Basic Installation & Configuration As the settings of the destination There are seven authentication types underInfrastructure mode Basic Installation & Configuration WEP Key Basic Installation & Configuration 6 802.1x Setting Reauthentication, Roaming, SameSsidand Always CA Server Basic Installation & Configuration GW-DS300N Link Status GW-DS300N Statistics Items Descriptions Transmit StatisticsReceive Statistics Buttons 3Advanced Configuration3 Auto-Based on the status of the network Advanced Configuration GW-DS300N QoS Not sit idle waiting for input that may never come Start PBC WPS ConÀgurationGW-DS300N II. Start PIN GW-DS300N Advanced Configuration About Advanced Configuration How to use AP mode Soft AP ModeConÀg Only and 802.11 B/G/N mix. Wireless Mode Scroll down the list to choose the wirelessShown in the4.3. Security Setting Short Slot GW-DS300N ItemsDescriptions Authentication Security SettingGW-DS300N Soft AP Mode Disable ,Allow All , andReject All . The default Access ControlSoft AP Mode AID MAC TableSoft AP Mode Event Log Soft AP Mode Frames Transmitted Successfully After Retry Buttons Utility and Driver. Eeprom Electrically Soft AP Mode