Lucent Technologies GW-DS300N manual 6 802.1x Setting

Page 37

22.6 802.1x Setting

Click“Authentication and Security”tab on the page of“Add Profile”and then click“802.1x Setting”, and the following picture will pop up. Please refer to the following instructions to configure GW-DS300N. The 802.1x authentication is mainly focus on“WPA”and“WPA2”encryption.

ItemsDescriptions

Certification

Authentication Type 1.PEAP–Pronounced“peep”and short for Protected Extensible Authentication Protocol, a protocol developed jointly by Microsoft, RSA Security and Cisco for transmitting authentication data, including passwords, over 802.11 wireless networks. And it requires a set of user name and password in addition. Enter the“User Name”and “Password”and also select a certificate from the “Certificate”list. To get the certificate and the personal user name and password, please contact with your administrator.

2.TLS Smart Card–Short for Transport Layer Security, a protocol that guarantees privacy and data integrity between client/server applications communicating over the Internet.

3.TTLS–Short for Tunneled Transport Layer Security, and is an advanced TLS protocol.

4.Md5-Challenge–It is the easiest EAP Type. It requires the wireless station to enter a set of user name and password as the identity to RADIUS Server. (Only“Open”and“Shared”encryption mode can use this function.)

32

GW-DS300N

Image 37
Contents Page IEEE802.11n Wireless PCIBus Adapter Foreword FCC Certifications Contents Advanced Configuration Introduction to GW-DS300N Features Package ContentsProduct Functions 2Basic Installation & Configuration How to install the driver and utility Basic Installation & Configuration GW-DS300N Basic Installation & Configuration How to make a wireless connection Basic Installation & Configuration GW-DS300N Authentication and Security Click on the Authentication GW-DS300N Basic Installation & Configuration GW-DS300N Site Survey Use Zero Configuration as Configuration utility Launch Config UtiltiesSwitch to AP Mode ExitClickConnect Items DescriptionsAd-hocandInfrastructure Unknown,WPA-PSK,WPA2-PSK,WPAProÀle PSM Power Saving Mode When GW-DS300N Items Descriptions ConfigurationBasic Installation & Configuration GW-DS300N Basic Installation & Configuration Authentication and Security Basic Installation & Configuration There are seven authentication types under As the settings of the destinationInfrastructure mode Basic Installation & Configuration WEP Key Basic Installation & Configuration 6 802.1x Setting Reauthentication, Roaming, SameSsidand Always CA Server Basic Installation & Configuration GW-DS300N Link Status GW-DS300N Items Descriptions Transmit Statistics StatisticsReceive Statistics Buttons 3Advanced Configuration3 Auto-Based on the status of the network Advanced Configuration GW-DS300N QoS Not sit idle waiting for input that may never come Start PBC WPS ConÀgurationGW-DS300N II. Start PIN GW-DS300N Advanced Configuration About Advanced Configuration How to use AP mode Soft AP ModeConÀg Only and 802.11 B/G/N mix. Wireless Mode Scroll down the list to choose the wirelessShown in the4.3. Security Setting Short Slot GW-DS300N ItemsDescriptions Authentication Security SettingGW-DS300N Soft AP Mode Disable ,Allow All , andReject All . The default Access ControlSoft AP Mode AID MAC TableSoft AP Mode Event Log Soft AP Mode Frames Transmitted Successfully After Retry Buttons Utility and Driver. Eeprom Electrically Soft AP Mode