GarrettCom Magnum 3000 manual Bonus port for optional PM card BPM shown, Cbl-Aui

CBL-AUI

Pin 1 (red)

Magnum 3000 Stackable Hubs Installation and User Guide (07/06)

When installing a PM into the Bonus Port slot of the Magnum 3024, use the 16-pin header labeled P1 (also labeled RPM) on the circuit board corresponding to ports 13-24. The red stripe of the connector cable should connect to pin 1 of header P1.

Bonus port for optional

PM card (BPM shown)

J1

(AUI)

P1

(RPM)

NOTE:

Use J1 (AUI) and for Basic AUI ports Use P1 (RPM) for PMs

PM Ribbon cable with 16 pin connector.

(Included only when PM is factory

May be ordered separately as part # CBL-PM)

NOTE: The PM will still function if connected to header J1/B of the circuit board corresponding to ports 1-12. However, this is not advised, as the port will not be recognized by an SNMP Agent (if one is present).

Figure 2.5d: Magnum 3024 internal layout with configured Bonus Port

CBL-AUI

When the RPM-AUI is factory configured as a bonus port, it is implemented with CBL-AUI, an AUI

connector with a ribbon cable, to

the 16-pin header J1 (AUI) on

the main board (Shown in both figure 2.5a and 2.5b). Since the

AUI functionality is build onto the main board, using CBL-AUI

is identical to the RPM-AUI. GCI recommends that RPM-AUI units should not get installed in the bonus port of both 3012’s and 3024’s.

www . GarrettCom . com

14