Enterasys Networks 6H352-25 manual Network Requirements

Page 10

2

3

4

A

B

NETWORK REQUIREMENTS

2.1	SmartTrunk Feature	2-1
2.2	10BASE-T Network	2-1
2.3	100BASE-TX Network	2-2

INSTALLATION

3.1	Unpacking the 6H352-25	3-2
3.2	Installing Optional HSIM, VHSIM, or Flash Memory Upgrade	3-2
3.3	Installing the Module into the MATRIX E7 Chassis	3-3
3.4	Installing the Module into the SmartSwitch Chassis	3-5
3.5	Connecting to the Network	3-7
3.6	Completing the Installation	3-10

TROUBLESHOOTING

4.1	Using LANVIEW	4-1
4.2	Troubleshooting Checklist	4-5
4.3	Using the RESET Button	4-7

SPECIFICATIONS

A.1	COM Port Pinout Assignments	A-2
A.2	Regulatory Compliance	A-3

MODE SWITCH BANK SETTINGS AND OPTIONS

B.1	Required Tools		B-1
B.2	Setting the Mode Switches		B-2
B.3	FLASH Memory Upgrade		B-4
	B.3.1	Locating the FLASH Memory	B-4
	B.3.2	Installing the FLASH Memory	B-5
B.4	Installing Optional HSIM or VHSIM Interface Modules		B-6

INDEX

viiiContents

Image 10

Contents 6H352-25 Fast Ethernet Installation Guide Page Page Industry Canada Notice FCC NoticeVcci Notice Enterasys NETWORKS, INC Program License Agreement Page Declaration of Conformity Page Contents Network Requirements Figures Tables Using this Guide About This GuideStructure of this Guide Related DocumentsDocument Conventions Guide uses the following conventionsGetting Help Introduction 6H352-25 Module Optional HSIMs and VHSIMs ConnectivityRuntime IP Address Discovery SmartTrunk HALF-DUPLEX/FULL-DUPLEX AUTO-NEGOTIATIONRemote Monitoring Rmon PORT/VLAN Redirect Functions Broadcast SuppressionTraffic Rate Limiting Flow Control Garp Switch Operation12 802.1 Port Priority Distributed Chassis Management Switching OptionsManagement Lanview Diagnostic LEDs Standards CompatibilityNetwork Requirements SmartTrunk Feature10BASE-T Network 100BASE-TX Network Installation Installing Optional HSIM, VHSIM, or Flash Memory Upgrade Unpacking the 6H352-25Installing the Module Into the Matrix E7 Chassis Installing the 6H352-25 into the Matrix E7 Chassis Installing the Module Into the SmartSwitch Chassis Installing the 6H352-25 into the SmartSwitch 6000 Chassis Connecting to the Network RX LED TX LED Crossover Cable RJ45 Pinouts Completing the Installation Troubleshooting Using LanviewGroup Select No link Is enabled and there is a Troubleshooting Checklist OFFRefer to Matrix E7 Series Using the Reset Button Reset Button8Troubleshooting Specifications PortsCOM Port Pinout Assignments EnvironmentalRegulatory Compliance Page Mode Switch Bank Settings and Options Required ToolsSetting the Mode Switches Figure B-1 Mode Switch LocationSetting the Mode Switches Flash Memory Upgrade Locating the Flash MemoryInstalling the Flash Memory Installing Optional Hsim or Vhsim Interface Modules Figure B-4 Hsim and Vhsim Connector LocationsIndex NumericsIndex-2