Enterasys Networks 6H352-25 manual Setting the Mode Switches, Figure B-1 Mode Switch Location

Page 50

Setting the Mode Switches

B.2 SETTING THE MODE SWITCHES

CAUTION: Read the appropriate sections to be fully aware of the consequences when changing switch settings.

Only qualified personnel should change switch settings.

Figure B-1shows the location of the mode switches and the switch settings for normal operation. These switches are set at the factory and rarely need to be changed.

Switch definitions and positions are as follows:

Switches 1 through 4 – For Enterasys Networks use only.

Switch 5 – COM Port Autobaud. The default (OFF) position enables Autobaud sensing on the COM port for Local Management sessions. Changing the switch to the ON position disables Autobaud sensing and sets the COM port to 9600 baud for Local Management sessions.

Figure B-1 Mode Switch Location

MODE SWITCH

ON

8

7

6

5

4

3

2

1

Memory Board

3547_09

B-2Mode Switch Bank Settings and Options

Image 50
Contents 6H352-25 Fast Ethernet Installation Guide Page Page Vcci Notice FCC NoticeIndustry Canada Notice Enterasys NETWORKS, INC Program License Agreement Page Declaration of Conformity Page Contents Network Requirements Figures Tables Using this Guide About This GuideStructure of this Guide Related DocumentsDocument Conventions Guide uses the following conventionsGetting Help Introduction 6H352-25 Module Runtime IP Address Discovery ConnectivityOptional HSIMs and VHSIMs Remote Monitoring Rmon HALF-DUPLEX/FULL-DUPLEX AUTO-NEGOTIATIONSmartTrunk Traffic Rate Limiting Broadcast SuppressionPORT/VLAN Redirect Functions 12 802.1 Port Priority Garp Switch OperationFlow Control Management Switching OptionsDistributed Chassis Management Lanview Diagnostic LEDs Standards Compatibility10BASE-T Network SmartTrunk FeatureNetwork Requirements 100BASE-TX Network Installation Installing Optional HSIM, VHSIM, or Flash Memory Upgrade Unpacking the 6H352-25Installing the Module Into the Matrix E7 Chassis Installing the 6H352-25 into the Matrix E7 Chassis Installing the Module Into the SmartSwitch Chassis Installing the 6H352-25 into the SmartSwitch 6000 Chassis Connecting to the Network RX LED TX LED Crossover Cable RJ45 Pinouts Completing the Installation Troubleshooting Using LanviewGroup Select No link Is enabled and there is a Troubleshooting Checklist OFFRefer to Matrix E7 Series Using the Reset Button Reset Button8Troubleshooting Specifications PortsCOM Port Pinout Assignments EnvironmentalRegulatory Compliance Page Mode Switch Bank Settings and Options Required ToolsSetting the Mode Switches Figure B-1 Mode Switch LocationSetting the Mode Switches Flash Memory Upgrade Locating the Flash MemoryInstalling the Flash Memory Installing Optional Hsim or Vhsim Interface Modules Figure B-4 Hsim and Vhsim Connector LocationsIndex NumericsIndex-2