Enterasys Networks 6H352-25 manual FCC Notice, Industry Canada Notice, Vcci Notice

Page 4

FCC NOTICE

This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

NOTE: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment uses, generates, and can radiate radio frequency energy and if not installed in accordance with the operator’s manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause interference in which case the user will be required to correct the interference at his own expense.

WARNING: Changes or modifications made to this device which are not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

INDUSTRY CANADA NOTICE

This digital apparatus does not exceed the Class A limits for radio noise emissions from digital apparatus set out in the Radio Interference Regulations of the Canadian Department of Communications.

Le présent appareil numérique n’émet pas de bruits radioélectriques dépassant les limites applicables aux appareils numériques de la class A prescrites dans le Règlement sur le brouillage radioélectrique édicté par le ministère des Communications du Canada.

VCCI NOTICE

This is a Class A product based on the standard of the Voluntary Control Council for Interference by Information Technology Equipment (VCCI). If this equipment is used in a domestic environment, radio disturbance may arise. When such trouble occurs, the user may be required to take corrective actions.

Image 4
Contents 6H352-25 Fast Ethernet Installation Guide Page Page Industry Canada Notice FCC NoticeVcci Notice Enterasys NETWORKS, INC Program License Agreement Page Declaration of Conformity Page Contents Network Requirements Figures Tables Using this Guide About This GuideStructure of this Guide Related DocumentsDocument Conventions Guide uses the following conventionsGetting Help Introduction 6H352-25 Module Optional HSIMs and VHSIMs ConnectivityRuntime IP Address Discovery SmartTrunk HALF-DUPLEX/FULL-DUPLEX AUTO-NEGOTIATIONRemote Monitoring Rmon PORT/VLAN Redirect Functions Broadcast SuppressionTraffic Rate Limiting Flow Control Garp Switch Operation12 802.1 Port Priority Distributed Chassis Management Switching OptionsManagement Lanview Diagnostic LEDs Standards CompatibilityNetwork Requirements SmartTrunk Feature10BASE-T Network 100BASE-TX Network Installation Installing Optional HSIM, VHSIM, or Flash Memory Upgrade Unpacking the 6H352-25Installing the Module Into the Matrix E7 Chassis Installing the 6H352-25 into the Matrix E7 Chassis Installing the Module Into the SmartSwitch Chassis Installing the 6H352-25 into the SmartSwitch 6000 Chassis Connecting to the Network RX LED TX LED Crossover Cable RJ45 Pinouts Completing the Installation Troubleshooting Using LanviewGroup Select No link Is enabled and there is a Troubleshooting Checklist OFFRefer to Matrix E7 Series Using the Reset Button Reset Button8Troubleshooting Specifications PortsCOM Port Pinout Assignments EnvironmentalRegulatory Compliance Page Mode Switch Bank Settings and Options Required ToolsSetting the Mode Switches Figure B-1 Mode Switch LocationSetting the Mode Switches Flash Memory Upgrade Locating the Flash MemoryInstalling the Flash Memory Installing Optional Hsim or Vhsim Interface Modules Figure B-4 Hsim and Vhsim Connector LocationsIndex NumericsIndex-2