Enterasys Networks 6H352-25 manual Document Conventions, Guide uses the following conventions

Page 15

Document Conventions

DOCUMENT CONVENTIONS

The guide uses the following conventions:

NOTE: Calls the reader’s attention to any item of information that may be of special importance.

TIP: Conveys helpful hints concerning procedures or actions.

CAUTION: Contains information essential to avoid damage to the equipment.

ELECTRICAL HAZARD: Warns against an action that could result in personal injury or death due to an electrical hazard.

WARNING: Warns against an action that could result in personal injury or death.

About This Guide

xiii

Image 15
Contents 6H352-25 Fast Ethernet Installation Guide Page Page FCC Notice Industry Canada NoticeVcci Notice Enterasys NETWORKS, INC Program License Agreement Page Declaration of Conformity Page Contents Network Requirements Figures Tables About This Guide Using this GuideRelated Documents Structure of this GuideGuide uses the following conventions Document ConventionsGetting Help Introduction 6H352-25 Module Connectivity Optional HSIMs and VHSIMsRuntime IP Address Discovery HALF-DUPLEX/FULL-DUPLEX AUTO-NEGOTIATION SmartTrunkRemote Monitoring Rmon Broadcast Suppression PORT/VLAN Redirect FunctionsTraffic Rate Limiting Garp Switch Operation Flow Control12 802.1 Port Priority Switching Options Distributed Chassis ManagementManagement Standards Compatibility Lanview Diagnostic LEDsSmartTrunk Feature Network Requirements10BASE-T Network 100BASE-TX Network Installation Unpacking the 6H352-25 Installing Optional HSIM, VHSIM, or Flash Memory UpgradeInstalling the Module Into the Matrix E7 Chassis Installing the 6H352-25 into the Matrix E7 Chassis Installing the Module Into the SmartSwitch Chassis Installing the 6H352-25 into the SmartSwitch 6000 Chassis Connecting to the Network RX LED TX LED Crossover Cable RJ45 Pinouts Completing the Installation Using Lanview TroubleshootingGroup Select No link Is enabled and there is a OFF Troubleshooting ChecklistRefer to Matrix E7 Series Reset Button Using the Reset Button8Troubleshooting Ports SpecificationsEnvironmental COM Port Pinout AssignmentsRegulatory Compliance Page Required Tools Mode Switch Bank Settings and OptionsFigure B-1 Mode Switch Location Setting the Mode SwitchesSetting the Mode Switches Locating the Flash Memory Flash Memory UpgradeInstalling the Flash Memory Figure B-4 Hsim and Vhsim Connector Locations Installing Optional Hsim or Vhsim Interface ModulesNumerics IndexIndex-2