Enterasys Networks 6H352-25 manual Standards Compatibility, Lanview Diagnostic LEDs

Page 24

Standards Compatibility

1.16 STANDARDS COMPATIBILITY

The 6H352-25 is fully compliant with the IEEE 802.3, 802.3u, 802.3x, 802.1D, and 802.1Q standards. The 6H352-25 provides IEEE 802.1D Spanning Tree Algorithm (STA) support to enhance the overall reliability of the network and protect against “loop” conditions. The 6H352-25 supports a wide variety of industry standard MIBs including RFC 1213 (MIB II), RFC 1757 (RMON), RFC 1493 (Bridge MIB), RFC 1354 (FIB MIB), and RFC 1190 (Path MTU Discovery). A full suite of Enterasys Networks Enterprise MIBs provide a wide array of statistical information to enhance troubleshooting. For information on how to extract and compile individual MIBs, contact Enterasys Networks.

1.17 LANVIEW DIAGNOSTIC LEDs

LANVIEW diagnostic LEDs serve as an important troubleshooting aid by providing an easy way to observe the status of individual ports and overall network operations.

1-8Introduction

Image 24

Contents 6H352-25 Fast Ethernet Installation Guide Page Page FCC Notice Industry Canada NoticeVcci Notice Enterasys NETWORKS, INC Program License Agreement Page Declaration of Conformity Page Contents Network Requirements Figures Tables Using this Guide About This GuideStructure of this Guide Related DocumentsDocument Conventions Guide uses the following conventionsGetting Help Introduction 6H352-25 Module Connectivity Optional HSIMs and VHSIMsRuntime IP Address Discovery HALF-DUPLEX/FULL-DUPLEX AUTO-NEGOTIATION SmartTrunkRemote Monitoring Rmon Broadcast Suppression PORT/VLAN Redirect FunctionsTraffic Rate Limiting Garp Switch Operation Flow Control12 802.1 Port Priority Switching Options Distributed Chassis ManagementManagement Lanview Diagnostic LEDs Standards CompatibilitySmartTrunk Feature Network Requirements10BASE-T Network 100BASE-TX Network Installation Installing Optional HSIM, VHSIM, or Flash Memory Upgrade Unpacking the 6H352-25Installing the Module Into the Matrix E7 Chassis Installing the 6H352-25 into the Matrix E7 Chassis Installing the Module Into the SmartSwitch Chassis Installing the 6H352-25 into the SmartSwitch 6000 Chassis Connecting to the Network RX LED TX LED Crossover Cable RJ45 Pinouts Completing the Installation Troubleshooting Using LanviewGroup Select No link Is enabled and there is a Troubleshooting Checklist OFFRefer to Matrix E7 Series Using the Reset Button Reset Button8Troubleshooting Specifications PortsCOM Port Pinout Assignments EnvironmentalRegulatory Compliance Page Mode Switch Bank Settings and Options Required ToolsSetting the Mode Switches Figure B-1 Mode Switch LocationSetting the Mode Switches Flash Memory Upgrade Locating the Flash MemoryInstalling the Flash Memory Installing Optional Hsim or Vhsim Interface Modules Figure B-4 Hsim and Vhsim Connector LocationsIndex NumericsIndex-2