Enterasys Networks 6H352-25 manual Getting Help

Page 16

Getting Help

GETTING HELP

For additional support related to the module or this document, contact us using one of the following methods:

World Wide Web

http://www.enterasys.com/

Phone

(603) 332-9400

 

 

Internet mail

support@enterasys.com

 

 

FTP

ftp://ftp.enterasys.com

Login

anonymous

Password

your email address

To send comments or suggestions concerning this document, contact the Technical Writing Department via the following email address: TechWriting@enterasys.com

Make sure to include the document Part Number in the email message.

Before contacting Enterasys Networks, have the following information ready:

Your Enterasys Networks service contract number

A description of the failure

A description of any action(s) already taken to resolve the problem (e.g., changing mode switches, rebooting the unit, etc.)

The serial and revision numbers of all involved Enterasys Networks products in the network

A description of your network environment (layout, cable type, etc.)

Network load and frame size at the time of trouble (if known)

The device history (i.e., have you returned the device before, is this a recurring problem, etc.)

Any previous Return Material Authorization (RMA) numbers

xivAbout This Guide

Image 16
Contents 6H352-25 Fast Ethernet Installation Guide Page Page Industry Canada Notice FCC NoticeVcci Notice Enterasys NETWORKS, INC Program License Agreement Page Declaration of Conformity Page Contents Network Requirements Figures Tables Using this Guide About This GuideStructure of this Guide Related DocumentsDocument Conventions Guide uses the following conventionsGetting Help Introduction 6H352-25 Module Optional HSIMs and VHSIMs ConnectivityRuntime IP Address Discovery SmartTrunk HALF-DUPLEX/FULL-DUPLEX AUTO-NEGOTIATIONRemote Monitoring Rmon PORT/VLAN Redirect Functions Broadcast SuppressionTraffic Rate Limiting Flow Control Garp Switch Operation12 802.1 Port Priority Distributed Chassis Management Switching OptionsManagement Lanview Diagnostic LEDs Standards CompatibilityNetwork Requirements SmartTrunk Feature10BASE-T Network 100BASE-TX Network Installation Installing Optional HSIM, VHSIM, or Flash Memory Upgrade Unpacking the 6H352-25Installing the Module Into the Matrix E7 Chassis Installing the 6H352-25 into the Matrix E7 Chassis Installing the Module Into the SmartSwitch Chassis Installing the 6H352-25 into the SmartSwitch 6000 Chassis Connecting to the Network RX LED TX LED Crossover Cable RJ45 Pinouts Completing the Installation Troubleshooting Using LanviewGroup Select No link Is enabled and there is a Troubleshooting Checklist OFFRefer to Matrix E7 Series Using the Reset Button Reset Button8Troubleshooting Specifications PortsCOM Port Pinout Assignments EnvironmentalRegulatory Compliance Page Mode Switch Bank Settings and Options Required ToolsSetting the Mode Switches Figure B-1 Mode Switch LocationSetting the Mode Switches Flash Memory Upgrade Locating the Flash MemoryInstalling the Flash Memory Installing Optional Hsim or Vhsim Interface Modules Figure B-4 Hsim and Vhsim Connector LocationsIndex NumericsIndex-2