Enterasys Networks 6H352-25 manual Installing the Flash Memory

Page 53

FLASH Memory Upgrade

B.3.2 Installing the FLASH Memory

CAUTION: Observe all antistatic precautions when handling sensitive electronic equipment.

To install a FLASH memory, refer to Figure B-3and proceed as follows:

1.With the FLASH memory oriented as shown in Figure B-3, insert the FLASH memory down between the connector.

2.Pivot the FLASH memory downward so the connector clips align with the two side notches of the FLASH memory and the connector clips lock the FLASH memory into place.

Figure B-3 Installing the FLASH Memory

2

FLASH

Connector Clip

1

Clip

3547_11

Mode Switch Bank Settings and Options

B-5

Image 53

Contents 6H352-25 Fast Ethernet Installation Guide Page Page Vcci Notice FCC NoticeIndustry Canada Notice Enterasys NETWORKS, INC Program License Agreement Page Declaration of Conformity Page Contents Network Requirements Figures Tables About This Guide Using this GuideRelated Documents Structure of this GuideGuide uses the following conventions Document ConventionsGetting Help Introduction 6H352-25 Module Runtime IP Address Discovery ConnectivityOptional HSIMs and VHSIMs Remote Monitoring Rmon HALF-DUPLEX/FULL-DUPLEX AUTO-NEGOTIATIONSmartTrunk Traffic Rate Limiting Broadcast SuppressionPORT/VLAN Redirect Functions 12 802.1 Port Priority Garp Switch OperationFlow Control Management Switching OptionsDistributed Chassis Management Standards Compatibility Lanview Diagnostic LEDs10BASE-T Network SmartTrunk FeatureNetwork Requirements 100BASE-TX Network Installation Unpacking the 6H352-25 Installing Optional HSIM, VHSIM, or Flash Memory UpgradeInstalling the Module Into the Matrix E7 Chassis Installing the 6H352-25 into the Matrix E7 Chassis Installing the Module Into the SmartSwitch Chassis Installing the 6H352-25 into the SmartSwitch 6000 Chassis Connecting to the Network RX LED TX LED Crossover Cable RJ45 Pinouts Completing the Installation Using Lanview TroubleshootingGroup Select No link Is enabled and there is a OFF Troubleshooting ChecklistRefer to Matrix E7 Series Reset Button Using the Reset Button8Troubleshooting Ports SpecificationsEnvironmental COM Port Pinout AssignmentsRegulatory Compliance Page Required Tools Mode Switch Bank Settings and OptionsFigure B-1 Mode Switch Location Setting the Mode SwitchesSetting the Mode Switches Locating the Flash Memory Flash Memory UpgradeInstalling the Flash Memory Figure B-4 Hsim and Vhsim Connector Locations Installing Optional Hsim or Vhsim Interface ModulesNumerics IndexIndex-2