Enterasys Networks 6H352-25 manual Installation

Page 27

3

Installation

ELECTRICAL HAZARD: Only qualified personnel should install the 6H352-25.

NOTE: Read the Release Notes shipped with the module to check for any exceptions to the supported features and operation documented in this guide.

This chapter provides the instructions to install the 6H352-25 module. A Phillips screwdriver is required to install options into the module. Follow the order of the sections listed below to correctly install the module.

•Unpacking the 6H352-25 (Section 3.1)

•Installing Optional HSIMs, VHSIMs or Memory Upgrade (Section 3.2)

•Installing the 6H352-25 into the MATRIX E7 Chassis (Section 3.3)

•Installing the 6H352-25 into the SmartSwitch 6000 Chassis (Section 3.4)

•Connecting to the Network (Section 3.5)

•Completing the Installation (Section 3.6)

Installation 3-1

Image 27

Contents 6H352-25 Fast Ethernet Installation Guide Page Page FCC Notice Industry Canada NoticeVcci Notice Enterasys NETWORKS, INC Program License Agreement Page Declaration of Conformity Page Contents Network Requirements Figures Tables About This Guide Using this GuideRelated Documents Structure of this GuideGuide uses the following conventions Document ConventionsGetting Help Introduction 6H352-25 Module Connectivity Optional HSIMs and VHSIMsRuntime IP Address Discovery HALF-DUPLEX/FULL-DUPLEX AUTO-NEGOTIATION SmartTrunkRemote Monitoring Rmon Broadcast Suppression PORT/VLAN Redirect FunctionsTraffic Rate Limiting Garp Switch Operation Flow Control12 802.1 Port Priority Switching Options Distributed Chassis ManagementManagement Standards Compatibility Lanview Diagnostic LEDsSmartTrunk Feature Network Requirements10BASE-T Network 100BASE-TX Network Installation Unpacking the 6H352-25 Installing Optional HSIM, VHSIM, or Flash Memory UpgradeInstalling the Module Into the Matrix E7 Chassis Installing the 6H352-25 into the Matrix E7 Chassis Installing the Module Into the SmartSwitch Chassis Installing the 6H352-25 into the SmartSwitch 6000 Chassis Connecting to the Network RX LED TX LED Crossover Cable RJ45 Pinouts Completing the Installation Using Lanview TroubleshootingGroup Select No link Is enabled and there is a OFF Troubleshooting ChecklistRefer to Matrix E7 Series Reset Button Using the Reset Button8Troubleshooting Ports SpecificationsEnvironmental COM Port Pinout AssignmentsRegulatory Compliance Page Required Tools Mode Switch Bank Settings and OptionsFigure B-1 Mode Switch Location Setting the Mode SwitchesSetting the Mode Switches Locating the Flash Memory Flash Memory UpgradeInstalling the Flash Memory Figure B-4 Hsim and Vhsim Connector Locations Installing Optional Hsim or Vhsim Interface ModulesNumerics IndexIndex-2