Enterasys Networks 6H352-25 manual Specifications, Ports

Page 45

A

Specifications

This appendix provides operating specifications for the Enterasys Networks 6H352-25 module. Enterasys Networks reserves the right to change the specifications at any time without notice.

Table 1-1 Specifications for the 6H352-25 Module

Item

Specification

 

 

I/O Ports

 

 

 

Ports 1 through 24

Fast Ethernet 10/100 Mbps (10BASE-T and 100BASE-TX

 

compliant) with 24 RJ45 connectors.

Interface Slot

Slot accepts optional High Speed Interface Module

 

(HSIM) or Very High Speed Interface Module (VHSIM) to

 

provide a variety of cabling connections.

 

 

Processors/Memory

 

 

 

Processors

Intel i960 HT RISC processor Power PC

Dynamic Random Access

32 MB

Memory (DRAM)

 

FLASH Memory

8 MB expandable to 16 MB

Shared Memory

4 MB

 

 

Physical

 

 

 

Dimensions

46.43 H x 6.05 W x 29.51 D (cm)

 

18.28 H x 2.38 W x 11.62 D (in)

Approximate Weight (Unit)

2.04 kg (4.5 lb)

MTBF (Predicted)

211,637 hours

Specifications A-1

Image 45
Contents 6H352-25 Fast Ethernet Installation Guide Page Page FCC Notice Industry Canada NoticeVcci Notice Enterasys NETWORKS, INC Program License Agreement Page Declaration of Conformity Page Contents Network Requirements Figures Tables About This Guide Using this GuideRelated Documents Structure of this GuideGuide uses the following conventions Document ConventionsGetting Help Introduction 6H352-25 Module Connectivity Optional HSIMs and VHSIMsRuntime IP Address Discovery HALF-DUPLEX/FULL-DUPLEX AUTO-NEGOTIATION SmartTrunkRemote Monitoring Rmon Broadcast Suppression PORT/VLAN Redirect FunctionsTraffic Rate Limiting Garp Switch Operation Flow Control12 802.1 Port Priority Switching Options Distributed Chassis ManagementManagement Standards Compatibility Lanview Diagnostic LEDsSmartTrunk Feature Network Requirements10BASE-T Network 100BASE-TX Network Installation Unpacking the 6H352-25 Installing Optional HSIM, VHSIM, or Flash Memory UpgradeInstalling the Module Into the Matrix E7 Chassis Installing the 6H352-25 into the Matrix E7 Chassis Installing the Module Into the SmartSwitch Chassis Installing the 6H352-25 into the SmartSwitch 6000 Chassis Connecting to the Network RX LED TX LED Crossover Cable RJ45 Pinouts Completing the Installation Using Lanview TroubleshootingGroup Select No link Is enabled and there is a OFF Troubleshooting ChecklistRefer to Matrix E7 Series Reset Button Using the Reset Button8Troubleshooting Ports SpecificationsEnvironmental COM Port Pinout AssignmentsRegulatory Compliance Page Required Tools Mode Switch Bank Settings and OptionsFigure B-1 Mode Switch Location Setting the Mode SwitchesSetting the Mode Switches Locating the Flash Memory Flash Memory UpgradeInstalling the Flash Memory Figure B-4 Hsim and Vhsim Connector Locations Installing Optional Hsim or Vhsim Interface ModulesNumerics IndexIndex-2