Enterasys Networks C2H124-48P, C2G124-48P manual Connecting AC and PoE Power, Switch Rear View

Connecting AC and PoE Power

Connecting AC and PoE Power

AC Power

Note: The power supply in the switch has automatic voltage sensing that allows connection to power sources ranging from 100 to 240 VAC.

To connect the switch to the power source, refer to Figure 3‐8 and proceed as follows:

1.Plug the power cord into the switch AC power connector.

2.Plug the other end of the power cord into a dedicated grounded AC outlet (not shown). The type of power outlet and power cord are country dependent.

Note: If you plan to connect all the switches quickly to allow automatic Manager selection, wait until all switches are fully operational before proceeding to the next step.

If you plan to power up each switch and allow it to become fully operational before applying power to the next switch, proceed to the next step.

Figure 3-8 Switch Rear View

TAC U

STACK OW

1505.A050-C-2A64L0I0MNHVEzAC AX

MACA

DDRESS

	Re
	DCdund
	+12LVinea/-n5t0PVower
	10.5AM/7A.SX5uAppMly
SER	AX,
	IAL NO.

À

ÁÂ

AC		LINE
100-
50-240			VAC
5		60
5.			Hz
	A
		MAX

1 AC power cord 2 AC power connector 3 Connector for external redundant power supply

SecureStack C2 Installation Guide 3-15