Enterasys Networks C2G124-48P manual High-Speed Stack Connections, C2H124-48P Stackable Switch

Overview

Caution: The C2G124-48P is a PoE-compliant device. Do not connect a SecureStack C2 Redundant Power System (C2RPS-SYS) to the power connector. Otherwise, damage to the device may result.

Precaución: El dispositivo C2G124-48P cumple con el estándar PoE. No conecte una fuente de poder redundante SecureStack C2 (C2RPS-SYS) al cable de corriente directa. De lo contrario, el dispositivo puede dañarse.

The 10/100 Mbps fixed front panel ports can operate in either half‐duplex or full‐duplex mode, as determined by Auto‐Negotiation.

Figure 1-2 C2H124-48P Stackable Switch

Ã

Front

1	2	3	4	5	6	7	8	9	10	11	12	13	14	15	16		17	18	19	20	21	22	23	24	25	26	27	28	29	30	31	32		33	34	35	36	37	38	39	40	41	42	43	44	45	46	47	48
1																15	17															31	33																47

MGR

RPS

UP

CPU DOWN

2 16 18 32 34 48

Å

49	50	51	52	C2H124-48P
	49		51
	50		52
				Console

ÁÂ

Back

STACK UP STACK DOWN

Ä À

Redundant Power Supply

AC LINE

100-240 VAC

50-60 Hz

7.5 A MAX

					MAC ADDRESS SERIAL NO.
	Æ	Ç	È		É
1	DB9 RS232 console port connector			6	Mini-GBIC port status LEDs
2	System Status LEDs			7	Two ports for stack connections
3	Twenty-four RJ45, 10/100 Mbps, PoE ports			8	Password Reset switch
4	RJ45 port status LEDS			9	AC power input connector
5	Four slots for SFP interface modules			10	Redundant power supply (RPS) DC
	(Mini-GBICs)				connector

High-Speed Stack Connections

The switch has rear‐panel connectors for high‐speed connections in a stack configuration. The high‐speed stacking cables used for the connections are optional items and must be ordered separately. There are two types of cables:

•a C2CAB‐SHORT cable to connect two adjacent switches in the stack, and

•a C2CAB‐LONG cable to connect from the top switch to the bottom switch in the stack. You need only one C2CAB‐LONG cable per stack.

1-4 Introduction