Enterasys Networks C2H124-48P Installing the Rubber Feet, Chassis Bottom, Rubber Feet Placement

Installing the Switch on a Flat Surface

Installing the Rubber Feet

To install the rubber feet, refer to Figure 3‐3 and proceed as follows:

1.Place the switch on its back on a sturdy flat surface to gain access to the bottom of the chassis.

2.Remove the four rubber feet from their plastic bag in the shipping box.

3.Locate the four marked locations on the bottom four corners of the chassis.

Figure 3-3 Chassis Bottom, Rubber Feet Placement

Á	À
Â	Â
Â	Â

1Bottom of chassis as seen when chassis is resting on its back

2Locations to install the rubber feet (four locations)

3Rubber feet with adhesive backing (four)

4.Remove the protective strip from the back of one rubber foot and position it on a marked location and press firmly into place. Repeat this procedure to install the remaining three rubber feet.

5.After installing the rubber feet, return the switch to its upright position.

Note: If a number of switches are being installed in a stack, repeat steps 1 through 4 to install the rubber feet on each switch before continuing with the installation.

6.To install switches on a flat surface proceed to “Guidelines for Flat Surface Installation” on page 3‐8. For a rackmount installation, proceed to “Rack Mounting the Switch” on page 3‐9.

SecureStack C2 Installation Guide 3-7