Enterasys Networks C2G124-48P manual C2H124-48P Lanview LEDs

Using LANVIEW

Figure 4-2 C2H124-48P LANVIEW LEDs

																									Æ																										Ç
Å
	1	2	3	4	5	6	7	8	9	10	11	12	13	14	15	16	17	18	19	20	21	22	23	24	25	26	27	28	29	30	31	32		33	34	35	36	37	38	39	40	41	42	43	44	45	46	47	48	49	50	51	52	C2H124-48
	1															15	17																31	33
																																																		47	49		51
	MGR
	RPS																																																		50		52
	UP
CPU	DOWN
	2															16	18																32	34																48				Console

MGR

RPS

UP

CPU DOWN

Ä

Ã

Â

Á

À

1	CPU LED	6	Link/Activity LED for 10/100 Mbps, port 1
2	STACK DOWN LED	7	Link/Activity LEDs for 10/100 Mbps,
3	STACK UP LED		RJ45 ports 1 through 48
4	RPS LED for redundant power-source status	8	Link/Activity LEDs for 1-Gbps Mini-GBIC
5	Manager LED		ports 49 through 521

1. Unlike the C2G124-48P, all 52 ports may be active at the same time.

Table 4‐1 describes the LED indications and provides recommended actions as appropriate.

Note: The terms flashing, blinking, and solid used in Table 4-1indicate the following:

Flashing: LED is flashing randomly.

Blinking: LED is flashing at a steady rate (approximately 50% on, 50% off).

Solid: LED is on steady and not pulsing.

SecureStack C2 Installation Guide 4-3