Enterasys Networks C2H124-48P manual Using Lanview, C2G124-48P Lanview LEDs

Using LANVIEW

Using LANVIEW

The switch uses the Enterasys Networks built‐in visual diagnostic and status monitoring system called LANVIEW. For the location of LANVIEW LEDs on the C2G124‐48P and C2H124‐48P, refer to Figure 4‐1 and Figure 4‐2, respectively. These LEDs allow you to quickly observe network status for diagnosing switch and network problems.

Figure 4-1 C2G124-48P LANVIEW LEDs
	Å																																														Æ
	1	2	3	4	5	6	7	8	9	10	11	12	13	14	15	16	17	18	19	20	21	22	23	24	25	26	27	28	29	30	31	32		33	34	35	36	37	38	39	40	41	42	43	44	45	46	47	48
	1															15	17																31	33															47
	MGR
	RPS
	UP
CPU	DOWN
	2															16	18																32	34															48

Ç

45	46	47	48	C2G124-48P
	45		47
	46		48
				Console

MGR

RPS

UP

CPU DOWN

Ä

Ã

Â

Á

À

1	CPU LED	6	Link/Activity/PoE LED for 10/100/1000 Mbps, RJ45 port 1
2	STACK DOWN LED	7	Link/Activity/PoE LEDs for 10/100/1000 Mbps
3	STACK UP LED		RJ45 ports 45 through 48
4	RPS LED for redundant power	8	Link/Activity LEDs for 1-Gbps Mini-GBIC ports 49 through
	source status		521

5Manager LED

1.These Mini-GBIC ports will only establish a link when the RJ45 port equivalent is not linked on a C2G124-48P. (For example: when Mini-GBIC port 45 is linked, RJ45 port 45 is deactivated. When Mini-GBIC is not linked, the RJ45 port 45 is reactivated and can establish a link as long as the Mini-GBIC port 45 is not linked first.)

4-2 Troubleshooting