Enterasys Networks C2H124-48P, C2G124-48P manual About This Guide, Who Should Use This Guide

About This Guide

This guide provides an overview, installation and troubleshooting instructions, and specifications for the Enterasys® SecureStack C2G124‐48P and C2H124‐48P stackable Gigabit Ethernet switches.

For information about the Command Line Interface (CLI) set of commands used to configure and manage the C2G124‐48P or C2H124‐48P, refer to the Enterasys Networks® SecureStack C2 Configuration Guide.

This preface provides an overview of this guide and the SecureStack C2 manual set, and explains the symbols used throughout this guide.

Note: In this guide, the following terms are used:

• Switch refers to both C2G124-48P and C2H124-48P, unless otherwise noted.

•MGBIC (Mini-Gigabit Interface Card) refers to optional small form pluggable (SFP) interface modules that plug into the fixed front panel MGBIC slots.

Important Notice

Depending on the firmware version used in the switch, some features described in this document may not be supported. Refer to the Release Notes shipped with the switch to determine which features are supported.

Who Should Use This Guide

This guide is intended for a network administrator responsible for installing and setting up the stackable switches.

Electrical Hazard: Only qualified personnel should perform installation procedures.

Riesgo Electrico: Solamente personal calificado debe realizar procedimientos de instalacion.

Elektrischer Gefahrenhinweis: Installationen sollten nur durch ausgebildetes und qualifiziertes Personal vorgenommen werden.

SecureStack C2 Installation Guide xv