Eaton Electrical Powerware 9315 Configuring the Serial Ports, Setup Serial Port 1 Screen

Communication

7.5 Configuring the Serial Ports

You must configure the port for communication using the LCD screen and buttons on the UPS Monitor Panel.

Select Port 1 from the Setup menu to display one of the Setup Port screens. The screens for Port 1 and Port 2 are identical, and allow you to specify settings for the two serial communication ports. Figure 7-5 shows the Setup Serial Port 1 screen.

NOTE You should configure only Port 1 unless field service has performed a wiring change for Port 2.

		Uninterruptible Power System
UPS System Normal						03 NOV 1997	14:23:45
Alarm:	None
Notice: None
Battery
Percent
100%			Setup Serial Port 1
		Mode	Rate	Data/Stop		Handshaking	Save
		TERMINAL	9600	8	1	XON / XOFF	NO
Setup
Port 1
Port 2
Time
Meters	Events	Statistics Graphics	Setup

Figure 7-5. Setup Serial Port 1 Screen

A small return arrow () appears in the upper right corner of the Setup Port screen. This

arrow is a reminder that you can press the button on the Monitor Panel to toggle the buttons between the menu box and the information area.

If the scroll bar is in the menu box, press the button to toggle to the information area. The first setting (Mode) is highlighted. Press the or button to move the highlight to the setting you want to change. To scroll through the available options for that setting, press the or button.

To save the settings upon exit from this screen, be sure the Save field is set to YES.

7-6 EATON Powerware® 9315 UPS (200–300 kVA) Operation Manual S 164201036 Rev F powerware.com