DigiTech RP1000 owner manual Warranty

Page 4

Warranty

We at DigiTech® are very proud of our products and back up each one we sell with the following

warranty:

1.The warranty registration card must be mailed within ten days after purchase date to validate this warranty.

2.DigiTech warrants this product, when used solely within the U.S., to be free from defects in materials and workmanship under normal use and service.

3.DigiTech liability under this warranty is limited to repairing or replacing defective materials that show evidence of defect, provided the product is returned to DigiTech WITH RETURN AUTHORIZATION, where all parts and labor will be covered up to a period of one year.A Return Authorization number may be obtained from DigiTech by telephone.The company shall not be liable for any consequential damage as a result of the product’s use in any circuit or assembly.

4.Proof-of-purchase is considered to be the burden of the consumer.

5.DigiTech reserves the right to make changes in design, or make additions to, or improvements upon this product without incurring any obligation to install the same on products previously manufactured.

6.The consumer forfeits the benefits of this warranty if the product’s main assembly is opened and tampered with by any- one other than a certified DigiTech technician or, if the product is used with AC voltages outside of the range suggested by the manufacturer.

7.The foregoing is in lieu of all other warranties, expressed or implied, and DigiTech neither assumes nor authorizes any person to assume any obligation or liability in connection with the sale of this product. In no event shall DigiTech or its dealers be liable for special or consequential damages or from any delay in the performance of this warranty due to causes beyond their control.

NOTE:The information contained in this manual is subject to change at any time without notification. Some information contained in this manual may also be inaccurate due to undocumented changes in the product or operating system since this version of the manual was completed.The information contained in this version of the owner’s manual supersedes all previous versions.

Declaration of Conformity

 

Manufacturer’s Name:

DigiTech

Manufacturer’s Address:

8760 S. Sandy Parkway

 

Sandy, Utah 84070, USA

declares that the product:

 

Product name:

RP1000

Product option:

all (requires Class II power adapter that conforms to the requirements of

 

EN60065, EN60742, or equivalent.)

conforms to the following Product Specifications:

Safety:

IEC 60065 (7th ed. 2001)

EMC:

EN 55013 (2001 + A1)

 

EN 55020 (1998)

Supplementary Information:

The product herewith complies with the requirements of the Low Voltage Directive 2006/95/EC and the EMC Directive 2004/108/EC.

 

Vice-President of Engineering

 

8760 S. Sandy Parkway

 

Sandy, Utah 84070, USA

 

Date: December 15, 2008

European Contact:

Your local DigiTech Sales and Service Office or

 

Harman Music Group

 

8760 South Sandy Parkway

 

Sandy, Utah 84070 USA

 

Ph: (801) 568-8800

 

Fax: (801) 568-7583

Image 4
Contents Owner’s Manual Page Table of Contents Warranty Preset Mode and Pedalboard Mode Getting AcquaintedIncluded Items About the RP1000Amp/Cabinet Bypass TunerTone Library Knob Effects Library KnobEditTMEditor/Librarian Presets Create Your Sound in Three Easy StepsAmp Gain/Effect Parameter Knob Amp Level/Effect Parameter KnobGuided Tour of the RP1000 Front PanelKnobs 1-6 From left to right Tone Library KnobEffects Library Knob Effects Level KnobMaster Volume Knob Bank Up/Down Footswitches13 -10 / Effects Footswitches Looper ButtonRear Panel Getting Started Making ConnectionsAmp Loop Stomp LoopConnection Setups Mono AmpMixer Stereo AmpsAmp Loop with Pre-Amp In Line ReturnAmp Loop using Guitar Amp’s Pre Amp Amp Loop and Stomp LoopStudio Setup Computer and Personal Monitors Preset Mode and Pedalboard Mode Applying PowerEditing Amp/Cabinet Models Editing/Creating PresetsAmp/Cabinet Bypass Storing/Copying/Naming a Preset Press the Store button again to save the changesBlock Diagram About the EffectsEffect Definitions WahDistortion Distortion Knob Gain EditTMAmplifier Gbsn1x12 Based on a ‘60 Gibson GA- 40 Jensen Speaker Chorus/FX Noise Gate/Auto SwellChorus Flanger Chorus KnobFlanger Knob DepthPhaser Phaser KnobVibrato viBRaTo Rotary Speaker RotaryUnicord Uni-VibeTMunovibe VibroPan vibropanTremolo/Panner Envelope Filter eNvfiltr DOD FX25 fx25 envAutoYa Auto YA YaYa ya yaStep Filter stepfltr Sample Hold smplholdDigiTech Whammy wHammy WhammyTMDetune DetUNe Pitch Shift PitCHHarmony Pitch Shifting harmony Delay Knob DelayBoss OC-2 OctaverTM octaver Reverb Types ReverbReverb Knob Expression Pedal Footswitch AssignLFOs Expression Update Factory ResetWah Min/Max Expression Pedal CalibrationBypass Preset LevelLooper Page USB Setup TunerPage Compressors WahsNoise Gates Chorus Stompbox Models FlangerPhasers PitchVibrato / Rotary TremoloDelays Envelope / SpecialReverbs DistortionsBoss DS-1 Distortion Boss MT-2 Metal ZoneBoss OD-1 Overdrive Boss SD-1 OverdriveAmps ‘77 Marshall Master Volume ‘65 Fender Blackface Deluxe Reverb’59 Gibson GA-40 ‘69 Hiwatt Custom 100 DR103DigiTech Blackbass ’65 Blackface preamp w/ Bassman poweramp DigiTech Bright CleanDigiTech Clean Tube ’95 Matchless ChieftainDigiTech Tweedface Tweed preamp w/Blackface poweramp DigiTech GSP2101TM Artist Clean TubeDigiTech Crunch DigiTech DarkmetalCabinets 4x12 ‘96 VHT Slant w/ Celestion Vintage 30’s 4x12 ‘07 Mesa/Boogie Rectifier w/Celestion Vintage 30’s2x12 DigiTech Bright 4x12 DigiTech Alt RockSpecifications Tone Library Effects LibraryWindows Software Requirements Mac Software RequirementsDigiTech South Sandy Parkway Sandy, Utah PH 801 FAX 801