Carrier Access Adit 3500 quick start Rack Mounting

Page 10

Quick Start Guide

Installation

Rack Mounting

This is an Optional Feature.

NOTE: Rack mounting kits are available for both 19 and 23 inch racks. 1 Rack Unit (RU) of spacing is required above the Adit 3000 in the Rack Mount Unit.

To rack mount the Adit 3000, follow the instructions below:

1.Attach bracket ears to Rack Mounting Tray using four #10-32 x 1/4" screws on each side. The Mounting Ears can be used for both a 19 or 23 inch rack. The drawing below shows a top view of the 2 versions.

Rack Mounting Tray

Mounting Ear

screws	Rack Mount Tray
screws
Mounting Ear	Front

23 in rack

screws

Mounting Ear

screws	Rack Mount Tray
screws
Mounting Ear	Front

19 in rack

screws

Mounting Ear

2.Attach the Rack Mounting Tray assembly (with mounting ears attached) to rack, using four #10-32 x 1/4” screws (two on each mounting ear).

3.Remove wall mount and screws, if attached, from Adit 3500 unit.

Note: Adit 3500 and wall mounting bracket are not assembled from the factory.

10	Adit 3500 - Release 1.6

Image 10

Contents Adit Page Quick Start Guide Electrostatic Discharge ESD Precautions Unpacking and InspectionInstallation Environment User SafetyInstallation Wall Mounting Rack Mounting Battery BackupCompliant Installation Ferrite Beads Ferrite beads shipped with Adit chassisSee Installation Environment on Wall MountingRack Mounting To rack mount the Adit 3000, follow the instructions belowTray Slide Battery Backup Installation#1 Adit 3500 mounted on top of the Battery Backup Attach Adit 3500 to the assembled BBU and brackets Attach power cords3500 #2 Adit 3500 and Battery Backup mounted to the wall Mount the Battery Backup to the wall with 4 #6 screws, byFront Adit 3500 Battery Backup Power ConnectorChassis Overview BackFront of Adit Interface ConnectorsGrounding the Unit Back of AditSpecification VAC Power ConnectionBattery Connection InputPin Name Description DS1/E1 Connection PortsDS1/E1 RJ-48C State Description10/100Base-TX Ethernet Ethernet RJ-45RS-232 Craft Port Female DB-9 Reset ButtonRJ-11 Connector Pin Direction DescriptionAlarm/Status LEDs CriticalWeb-Based Management To access the management consoleCommand Description #show interface ethernet 2 Eth WANSetting up a CLI Connection Set the New-line/Transmit value CR+LFKey Enabled Software Features LogKey Enabled Software Features Basic Configuration Setup Adit 3500 for access via Web-BrowserRestore Factory Defaults Select Restore DefaultsModify Default Admin User Quick Start Guide Configure WAN Interface for Internet Connectivity Single T1 PPPSet the proper Framing Type and Line Coding Quick Start Guide Quick Start Guide Multiple T1s Multilink Set the proper Framing Type and Line Coding Select click New Connection to create the ML-PPP connection Enter User Name and Password Quick Start Guide Quick Start Guide Ethernet WAN Quick Start Guide Configure the Adit 3500 as a SIP Gateway On the IP Telephony tab, under Proxy Servers Select Use SIP Proxy and enter SIP Proxy IP addressQuick Start Guide Quick Start Guide Repeat this step for each FXS Line Quick Start Guide Set the Signaling Type Quick Start Guide Quick Start Guide Basic Configuration Adit 3500 Release