Carrier Access Adit 3500 quick start Battery Backup, Installation

Page 12

Quick Start Guide

Installation

Battery Backup

This is an Optional Feature.

The Adit 3500 Battery Backup is designed specifically for the Adit 3500. The battery backup unit is a single 12V sealed lead-acid battery in a metal enclosure designed for wall mounting.

Installation

There are two possible configurations to wall mount the Adit 3500 and the Battery Backup.

NOTE: It is recommended that the BBU be mounted to a wooden backboard using (4) #6 screws, or to drywall using (4) #6 screws with anchors. These screws are not provided.

1.Battery Backup attached to wall, with Adit 3500 mounted on the Battery Backup

2.Adit 3500 and Battery Backup attached to wall.

Option 1

view from side

Adit 3500

Option 2

Wall

Battery Backup

12	Adit 3500 - Release 1.6

Image 12

Contents Adit Page Quick Start Guide Electrostatic Discharge ESD Precautions Unpacking and InspectionInstallation Environment User SafetyInstallation Wall Mounting Rack Mounting Battery BackupCompliant Installation Ferrite Beads Ferrite beads shipped with Adit chassisSee Installation Environment on Wall MountingRack Mounting To rack mount the Adit 3000, follow the instructions belowTray Slide Battery Backup Installation#1 Adit 3500 mounted on top of the Battery Backup Attach power cords Attach Adit 3500 to the assembled BBU and brackets3500 #2 Adit 3500 and Battery Backup mounted to the wall Mount the Battery Backup to the wall with 4 #6 screws, byAdit 3500 Battery Backup Power Connector Chassis OverviewFront BackInterface Connectors Grounding the UnitFront of Adit Back of AditVAC Power Connection Battery ConnectionSpecification InputDS1/E1 Connection Ports DS1/E1 RJ-48CPin Name Description State Description10/100Base-TX Ethernet Ethernet RJ-45Reset Button RJ-11 ConnectorRS-232 Craft Port Female DB-9 Pin Direction DescriptionAlarm/Status LEDs CriticalTo access the management console Command DescriptionWeb-Based Management #show interface ethernet 2 Eth WANSetting up a CLI Connection Set the New-line/Transmit value CR+LFKey Enabled Software Features LogKey Enabled Software Features Basic Configuration Setup Adit 3500 for access via Web-BrowserRestore Factory Defaults Select Restore DefaultsModify Default Admin User Quick Start Guide Configure WAN Interface for Internet Connectivity Single T1 PPPSet the proper Framing Type and Line Coding Quick Start Guide Quick Start Guide Multiple T1s Multilink Set the proper Framing Type and Line Coding Select click New Connection to create the ML-PPP connection Enter User Name and Password Quick Start Guide Quick Start Guide Ethernet WAN Quick Start Guide Configure the Adit 3500 as a SIP Gateway On the IP Telephony tab, under Proxy Servers Select Use SIP Proxy and enter SIP Proxy IP addressQuick Start Guide Quick Start Guide Repeat this step for each FXS Line Quick Start Guide Set the Signaling Type Quick Start Guide Quick Start Guide Basic Configuration Adit 3500 Release