Carrier Access Adit 3500 quick start Compliant Installation

Page 7

Quick Start Guide

Installation

Compliant Installation

NOTE: It is important the DS1/E1 Network Interface Cables are secured separately from the power and Signal Cables.

1.Inspect the unit.

2.Mount the unit.

zWall mounting installation, see Wall Mounting on page 9.

zWall mounting with Battery Backup Unit, see Battery Backup on page 12.

zRack mounting installation, see Rack Mounting on page 10.

3.Ground the unit.

WARNING! THE ADIT 3500 IS REQUIRED TO BE PERMANENTLY GROUNDED FOR THE PROTECTION OF USERS AND SERVICE PERSONNEL. REFER TO Grounding the Unit ON PAGE 3 FOR

DETAILED INSTRUCTIONS.

4.Connect DS1 (T1), and Ethernet connections as needed.

5.Connect RS-232 connector and connect via HyperTerm on your PC.

Note: With this running before power is enabled, you can monitor the boot process.

6.Attach PBX and phone line cables.

7.Connect Power to the unit.

8.Monitor the boot process on your PC, when complete the status light should be green.

9.For any software enabled features, enter the key command. See the key command in the Adit 3000 CLI Reference Manual, for detailed information.

10.To verify use the show version command.

11.To provision the unit. See Web-Based Management on page 23, for detailed instructions.

Adit 3500 - Release 1.6

7

Image 7

Contents Adit Page Quick Start Guide Unpacking and Inspection Electrostatic Discharge ESD PrecautionsUser Safety Installation EnvironmentWall Mounting Rack Mounting Battery Backup InstallationCompliant Installation Ferrite beads shipped with Adit chassis Ferrite BeadsWall Mounting See Installation Environment onTo rack mount the Adit 3000, follow the instructions below Rack MountingTray Slide Installation Battery Backup#1 Adit 3500 mounted on top of the Battery Backup Attach Adit 3500 to the assembled BBU and brackets Attach power cords3500 Mount the Battery Backup to the wall with 4 #6 screws, by #2 Adit 3500 and Battery Backup mounted to the wallBack Adit 3500 Battery Backup Power ConnectorChassis Overview FrontBack of Adit Interface ConnectorsGrounding the Unit Front of AditInput VAC Power ConnectionBattery Connection SpecificationState Description DS1/E1 Connection PortsDS1/E1 RJ-48C Pin Name DescriptionEthernet RJ-45 10/100Base-TX EthernetPin Direction Description Reset ButtonRJ-11 Connector RS-232 Craft Port Female DB-9Critical Alarm/Status LEDs#show interface ethernet 2 Eth WAN To access the management consoleCommand Description Web-Based ManagementSet the New-line/Transmit value CR+LF Setting up a CLI ConnectionLog Key Enabled Software FeaturesKey Enabled Software Features Setup Adit 3500 for access via Web-Browser Basic ConfigurationSelect Restore Defaults Restore Factory DefaultsModify Default Admin User Quick Start Guide Single T1 PPP Configure WAN Interface for Internet ConnectivitySet the proper Framing Type and Line Coding Quick Start Guide Quick Start Guide Multiple T1s Multilink Set the proper Framing Type and Line Coding Select click New Connection to create the ML-PPP connection Enter User Name and Password Quick Start Guide Quick Start Guide Ethernet WAN Quick Start Guide Configure the Adit 3500 as a SIP Gateway Select Use SIP Proxy and enter SIP Proxy IP address On the IP Telephony tab, under Proxy ServersQuick Start Guide Quick Start Guide Repeat this step for each FXS Line Quick Start Guide Set the Signaling Type Quick Start Guide Quick Start Guide Basic Configuration Adit 3500 Release