Carrier Access quick start #2 Adit 3500 and Battery Backup mounted to the wall

Quick Start Guide

Installation

#2 Adit 3500 and Battery Backup mounted to the wall

This method requires a more wall space. Note: This installation will require a minimum of wall

space of: 17" (H) x 14" (W) x 2.5" (D).

Adit 3500

Back Front

Battery Cable	Holds AC Adapter
	portion of power
	cord

Battery Backup

1. Mount the Battery Backup to the wall with (4) #6 screws, by:

zMark the location of the left-side 2 screws (using the BBU mounting keyhole as a guide). Note: this installation of the BBU is oriented with the mounting keyholes to the left side.

zScrew these 2 screws into the wall at marked locations. Note: do not screw tight to the wall, leave 1/4" to allow BBU mounting keyholes to slip over screw head.

zAttach the BBU by slipping the screw heads through the keyhole slots at the left of the BBU, and slide unit to the right to allow screwheads to enter the narrow end of the keyhole.

zScrew the second set of 2 screws into mounting holes on the right of the unit.

zTighten all screws to the wall.

2.Insert Adit 3500 Power cord through the holder on the top of the BBU. This supports the weight of the adapter portion of the power cord.

3.Attach Adit 3500 to the wall following the instructions, Wall Mounting on page 9. Attaching the Adit 3500 to the wall above the BBU.

Note: there is a distance limit between the Adit and the BBU (note the length of the battery cable to the Adit).

4.Attach power cords.

zConnect cord from BBU to the Adit 3500 (2 pin connector).

zConnect 12V power cord to Adit 3500.

Adit 3500 - Release 1.6 15