Carrier Access Adit 3500 quick start Enter User Name and Password

Page 38

Quick Start Guide

Basic Configuration

11.Enter User Name and Password.

12.Select the T1s for this Multilink and the channel ranges.

13.Select Next.

14. A summary of the Multilink connection will be displayed. If correct, select Finish.

38	Adit 3500 - Release 1.6

Image 38

Contents Adit Page Quick Start Guide Electrostatic Discharge ESD Precautions Unpacking and InspectionInstallation Environment User SafetyInstallation Wall Mounting Rack Mounting Battery BackupCompliant Installation Ferrite Beads Ferrite beads shipped with Adit chassisSee Installation Environment on Wall MountingRack Mounting To rack mount the Adit 3000, follow the instructions belowTray Slide Battery Backup Installation#1 Adit 3500 mounted on top of the Battery Backup 3500 Attach power cordsAttach Adit 3500 to the assembled BBU and brackets #2 Adit 3500 and Battery Backup mounted to the wall Mount the Battery Backup to the wall with 4 #6 screws, byFront Adit 3500 Battery Backup Power ConnectorChassis Overview BackFront of Adit Interface ConnectorsGrounding the Unit Back of AditSpecification VAC Power ConnectionBattery Connection InputPin Name Description DS1/E1 Connection PortsDS1/E1 RJ-48C State Description10/100Base-TX Ethernet Ethernet RJ-45RS-232 Craft Port Female DB-9 Reset ButtonRJ-11 Connector Pin Direction DescriptionAlarm/Status LEDs CriticalWeb-Based Management To access the management consoleCommand Description #show interface ethernet 2 Eth WANSetting up a CLI Connection Set the New-line/Transmit value CR+LFKey Enabled Software Features LogKey Enabled Software Features Basic Configuration Setup Adit 3500 for access via Web-BrowserRestore Factory Defaults Select Restore DefaultsModify Default Admin User Quick Start Guide Configure WAN Interface for Internet Connectivity Single T1 PPPSet the proper Framing Type and Line Coding Quick Start Guide Quick Start Guide Multiple T1s Multilink Set the proper Framing Type and Line Coding Select click New Connection to create the ML-PPP connection Enter User Name and Password Quick Start Guide Quick Start Guide Ethernet WAN Quick Start Guide Configure the Adit 3500 as a SIP Gateway On the IP Telephony tab, under Proxy Servers Select Use SIP Proxy and enter SIP Proxy IP addressQuick Start Guide Quick Start Guide Repeat this step for each FXS Line Quick Start Guide Set the Signaling Type Quick Start Guide Quick Start Guide Basic Configuration Adit 3500 Release