Carrier Access Adit 3500 quick start 10/100Base-TX Ethernet, Ethernet RJ-45

Page 20

Quick Start Guide

Interface Connectors

10/100Base-TX Ethernet

1

8

The 10/100Base-TX Ethernet (female) ports provide connectivity for Router WAN and/or LAN ports and for management connection via Telnet and/or SNMP to a Network Management System.

Ethernet (RJ-45)

The pinouts are as follows:

Note: This is a hub pinout, you will need a straight cable to connect to a PC.

Pin	Name	Description
1	Receive +	Receive from network

2	Receive -	Receive from network

3	Transmit +	Transmit to network

4-5	N/C	Not connected

6	Transmit -	Transmit to network

7-8	N/C	Not connected

The LEDs are as follows:

LED	State	Description
Left LED	The left LED shall show	Link Status.

	Off	Link Down

	Green	Link Up

	Flashing Green	Traffic on Link

	Yellow	Collision status

Right LED	The right LED shall indicate Link Speed.

	Off	10 Mbit/sec, down or not connected

	Green	100 Mbit/sec

20	Adit 3500 - Release 1.6

Image 20

Contents Adit Page Quick Start Guide Electrostatic Discharge ESD Precautions Unpacking and InspectionInstallation Environment User SafetyInstallation Wall Mounting Rack Mounting Battery BackupCompliant Installation Ferrite Beads Ferrite beads shipped with Adit chassisSee Installation Environment on Wall MountingRack Mounting To rack mount the Adit 3000, follow the instructions belowTray Slide Battery Backup Installation#1 Adit 3500 mounted on top of the Battery Backup 3500 Attach power cordsAttach Adit 3500 to the assembled BBU and brackets #2 Adit 3500 and Battery Backup mounted to the wall Mount the Battery Backup to the wall with 4 #6 screws, byAdit 3500 Battery Backup Power Connector Chassis OverviewFront BackInterface Connectors Grounding the UnitFront of Adit Back of AditVAC Power Connection Battery ConnectionSpecification InputDS1/E1 Connection Ports DS1/E1 RJ-48CPin Name Description State Description10/100Base-TX Ethernet Ethernet RJ-45Reset Button RJ-11 ConnectorRS-232 Craft Port Female DB-9 Pin Direction DescriptionAlarm/Status LEDs CriticalTo access the management console Command DescriptionWeb-Based Management #show interface ethernet 2 Eth WANSetting up a CLI Connection Set the New-line/Transmit value CR+LFKey Enabled Software Features LogKey Enabled Software Features Basic Configuration Setup Adit 3500 for access via Web-BrowserRestore Factory Defaults Select Restore DefaultsModify Default Admin User Quick Start Guide Configure WAN Interface for Internet Connectivity Single T1 PPPSet the proper Framing Type and Line Coding Quick Start Guide Quick Start Guide Multiple T1s Multilink Set the proper Framing Type and Line Coding Select click New Connection to create the ML-PPP connection Enter User Name and Password Quick Start Guide Quick Start Guide Ethernet WAN Quick Start Guide Configure the Adit 3500 as a SIP Gateway On the IP Telephony tab, under Proxy Servers Select Use SIP Proxy and enter SIP Proxy IP addressQuick Start Guide Quick Start Guide Repeat this step for each FXS Line Quick Start Guide Set the Signaling Type Quick Start Guide Quick Start Guide Basic Configuration Adit 3500 Release