Carrier Access Adit 3500 quick start Modify Default Admin User

Page 29

Quick Start Guide

Basic Configuration

Modify Default Admin User

For security purposes it is recommended that the Administrator User be changed from the default settings.

Modify the Administrator User in the web-browser:

zSelect Advanced from the Navigation bar

zSelect Users icon

zSelect Administrator, to open the profile.

Adit 3500 - Release 1.6

29

Image 29

Contents Adit Page Quick Start Guide Unpacking and Inspection Electrostatic Discharge ESD PrecautionsUser Safety Installation EnvironmentWall Mounting Rack Mounting Battery Backup InstallationCompliant Installation Ferrite beads shipped with Adit chassis Ferrite BeadsWall Mounting See Installation Environment onTo rack mount the Adit 3000, follow the instructions below Rack MountingTray Slide Installation Battery Backup#1 Adit 3500 mounted on top of the Battery Backup 3500 Attach power cordsAttach Adit 3500 to the assembled BBU and brackets Mount the Battery Backup to the wall with 4 #6 screws, by #2 Adit 3500 and Battery Backup mounted to the wallChassis Overview Adit 3500 Battery Backup Power ConnectorFront BackGrounding the Unit Interface ConnectorsFront of Adit Back of AditBattery Connection VAC Power ConnectionSpecification InputDS1/E1 RJ-48C DS1/E1 Connection PortsPin Name Description State DescriptionEthernet RJ-45 10/100Base-TX EthernetRJ-11 Connector Reset ButtonRS-232 Craft Port Female DB-9 Pin Direction DescriptionCritical Alarm/Status LEDsCommand Description To access the management consoleWeb-Based Management #show interface ethernet 2 Eth WANSet the New-line/Transmit value CR+LF Setting up a CLI ConnectionLog Key Enabled Software FeaturesKey Enabled Software Features Setup Adit 3500 for access via Web-Browser Basic ConfigurationSelect Restore Defaults Restore Factory DefaultsModify Default Admin User Quick Start Guide Single T1 PPP Configure WAN Interface for Internet ConnectivitySet the proper Framing Type and Line Coding Quick Start Guide Quick Start Guide Multiple T1s Multilink Set the proper Framing Type and Line Coding Select click New Connection to create the ML-PPP connection Enter User Name and Password Quick Start Guide Quick Start Guide Ethernet WAN Quick Start Guide Configure the Adit 3500 as a SIP Gateway Select Use SIP Proxy and enter SIP Proxy IP address On the IP Telephony tab, under Proxy ServersQuick Start Guide Quick Start Guide Repeat this step for each FXS Line Quick Start Guide Set the Signaling Type Quick Start Guide Quick Start Guide Basic Configuration Adit 3500 Release