Aiwa CX-NHMT25, NSX-HMT25, NSX-HMT26 operating instructions Loading Discs, Playing Discs

CD PLAYING

BASIC OPERATIONS

LOADING DISCS

Press CD, then press z OPEN/CLOSE to open the disc compartment. Load disc(s) with the label side up.

To play one or two discs, place the discs on tray 1 and 2.

To play three discs, press DISC CHANGE to rotate the trays after placing two discs. Place the third disc on tray 3.

Close the disc compartment by pressing z OPEN/CLOSE.

Tray number of the disc to be played

Total number of tracks Total playing time

PLAYING DISCS

Load discs.

To play all discs in the disc compartment, press c.

Play begins with the disc on tray 1.

Number of track being played Elapsed playing time

To play one disc only, press DISC DIRECT PLAY 1-3.

The selected disc is played once.

To stop play, press s.

To pause play, press a. To resume play, press again.

To search for a particular point during playback, keep f

or g pressed and release it at the desired point.

To skip to the beginning of a track during playback, press

f or g repeatedly or turn MULTI JOG.

To remove discs, press z OPEN/CLOSE.

To start play when the power is off (Direct Play Function)

Press CD. The power is turned on and play of the loaded disc(s) begins.

When zOPEN/CLOSE is pressed, the power is also turned on and the disc compartment is opened.

To check the remaining time

During play (except random play or programmed play), press CD EDIT/CHECK on the remote control. The amount of time remaining until all tracks finish playing is displayed. To restore the playing time display, repeat the above.

Selecting a track with the remote control

1Press DISC DIRECT PLAY, then press numbered buttons 1- 3 within 3 seconds to select a disc.

2Press numbered buttons 0-9and +10 to select a track. Example:

To select the 25th track, press +10, +10 and 5. To select the 10th track, press +10 and 0.

The selected track starts to play and continues to the end of that disc.

Replacing discs during play

While one disc is playing, the other discs can be replaced without interrupting play.

1Press DISC CHANGE.

2Remove the discs and replace with other discs.

3Press z OPEN/CLOSE to close the disc compartment.

•When loading an 8-cm (3-inch) disc, put it onto the inner circle of the tray.

•Do not place more than one compact disc on one disc tray.

•Do not tilt the unit with discs loaded. Doing so may cause malfunctions.

•Do not use irregular shape CDs (example: heart-shaped, octagonal ones). It may result in malfunctions.

•The unit may not play a CD-R/RW disc that is recorded on personal computers or some kinds of CD-R/RW recorders because of differences in recording platforms.

•Do not attach any seal or label to either side (the recordable side or the labeled side) of a CD-R/RW disc. It may cause malfunction.

12 ENGLISH