Aiwa CX-NHMT25, NSX-HMT25 Care and Maintenance, General, Tuner Section, Cassette Deck Section

Page 24

GENERAL

 

CARE AND MAINTENANCE

TROUBLESHOOTING GUIDE

Occasional care and maintenance of the unit and the software are needed to optimize the performance of your unit.

To clean the cabinet

Use a soft and dry cloth.

If the surfaces are extremely dirty, use a soft cloth lightly moistened with mild detergent solution. Do not use strong solvents, such as alcohol, benzine or thinner as these could damage the finish of the unit.

To clean the tape heads

When the tape heads are dirty;

-high frequency sound is not emitted

-the sound is not adequately high

-the sound is off-balance

-the tape cannot be erased

-the tape cannot be recorded on

After every 10 hours of use, clean the tape heads with a head cleaning cassette.

Refer to the instructions of the cleaning cassette for details.

To demagnetize the tape heads

The tape heads may become magnetized after long-term use. This may narrow the output range of recorded tapes and increase noise.

After every 20 to 30 hours of use, demagnetize the tape heads with a separately sold demagnetizing cassette.

Refer to the instructions of the demagnetizing cassette for details.

Care of discs

When a disc becomes dirty, wipe the disc from the center out with a cleaning cloth.

After playing a disc, store the disc in its case. Do not leave the disc in places that are hot or humid.

Care of tapes

Store tapes in their cases after use.

Do not leave tapes near magnets, motors, television sets, or any source of magnetism. This will downgrade the sound quality and cause noise.

Do not expose tapes to direct sunlight, or leave them in a car parked in direct sunlight.

To reset

If an unusual condition occurs in the display window or the cassette decks, reset the unit as follows.

1Press POWER to turn off the power.

2Press POWER to turn the power back on while pressing s CLEAR. Everything stored in memory after purchase is canceled.

If the power cannot be turned off in step 1 because of a malfunction, reset by disconnecting the AC cord, and connect it again. Then carry out step 2.

If the unit fails to perform as described in these Operating Instructions, check the following guide.

GENERAL

There is no sound.

Is the AC cord connected properly?

Is there a bad connection? (page 4, 5)

There may be a short circuit in the speaker terminals.

Disconnect the AC cord, then correct the speaker connections.

Was an incorrect function button pressed?

Sound is emitted from one speaker only.

Is the other speaker disconnected?

An erroneous display or a malfunction occurs.

Reset the unit as stated below.

The unit blacks out when the power is turned off.

Is the power economizing mode set to “ECO ON” or “ECO AUTO” ? (page 7)

The power is not turned on.

Disconnect the AC cord, and connect it again in a few seconds.

TUNER SECTION

There is constant, wave-like static.

Is the antenna connected properly? (page 5)

Is the signal weak?

Connect an outdoor antenna.

The reception contains noise interferences or the sound is distorted.

Is the system picking up external noise or multipath distortion?

Change the orientation of the antenna.

Move the unit away from other electrical appliances.

CASSETTE DECK SECTION

The tape does not run.

Is deck 2 in pause mode? (page 11)

The sound is off-balance or not adequately high.

Is the playback head dirty? (page 24)

Recording is not possible.

Is the erasure prevention tab on the tape broken off? (page 14)

Is the recording head dirty? (page 24)

Erasure is not possible.

Is the erasure head dirty? (page 24)

Is a metal tape being used?

High frequency sound is not emitted.

Is the recording/playback head dirty? (page 24)

CD PLAYER SECTION

The CD player does not play.

Is the disc correctly placed? (page 12)

Is the disc dirty? (page 24)

Is the lens affected by condensation?

Wait approximately one hour and try again.

24 ENGLISH

Image 24
Contents CX-NHMT25 Precautions InstallationElectric Power Table of Contents Before connecting the AC cord ConnectionsConnect the front speakers Connect the surround speakersPositioning the Speakers Connect the supplied antennasConnect the Television to the video equipment Connect the AC cord to an AC outletRemote Control Connecting AN Outdoor AntennaSetting Power Economizing Mode Dimmer ModeBefore Operation Flash WindowSetting the Clock Press Clock on the remote controlPress Enter or a Audio Adjustments VolumeGraphic Equalizer Super T-BASS SystemManual Tuning Presetting StationsPreset Number Tuning Basic Operations Press c to start playLoading Discs Playing DiscsPress Prgm in stop mode Programmed PlayRandom /REPEAT Play Press numbered buttons 0-9 and +10 to programBasic Recording Inserting Blank SpacesInsert the tape to be recorded on into deck Press w REC/REC Mute to start recordingDubbing a Tape Manually Press Tape Deck 1/2 to select deckPress Sync DUB to start recording To stop dubbingAI Edit Recording Insert the tape into deckPress w REC/REC Mute to start recording on First side Programmed Edit Recording To change the program of each sidePress Manual Select again to stop the noise signal To change the delay timePress Dolby PRO Logic to select Normal Check the followingAdditional Dolby PRO Logic Modes Press VIDEO/AUX and start playback of the video SourcePress Dolby PRO Logic Setting the Timer Adjust the volumePress Power to turn off the power Prepare the sourceTimer Recording To check the time remaining until the power is turned offTo cancel the sleep timer To start the game demo, press cwhen the power Is off Press s oncePress s twice to stop the remaining two numbers VIDEO/AUX Jacks CD Digital OUT Optical JackSUB Woofer Jack Press VIDEO/AUXCare and Maintenance GeneralTuner Section Cassette Deck SectionSpecifications Dolby PRO LogicCopyright Parts Index Precauciones AdvertenciaInstalación Energía eléctricaIndice Antena exteriorMantenimiento Daños que necesitan ser reparadosConexiones Conecte los altavoces delanterosConecte los altavoces de sonido ambiental Conecte el altavoz centralUbicacion DE LOS Altavoces Control Remoto Conexion DE UNA Antena ExteriorAntes DE LA Operacion Activacion DEL Modo DE Ahorro DE EnergiaModo DE Intensidad DE Iluminacio Ventanilla ParpadeantePulse Clock en el control remoto Pulse Enter o aPara reponer el ajuste original del reloj Para cambiar al modo de 24 horasControl DE Volumen Ajustes DE AudioEcualizador Grafico Sistema Super T-BASSSintonizacion Manual Preajuste DE EmisorasSintonizacion Mediante Numero DE Preajuste Pulse fDOWN o gUP para seleccionar una EmisoraOperaciones Basicas Pulse Tape y z Push Eject para abrir el portacasetePulse c para iniciar la reproducción Introduccion DE Discos Reproduccion DE DiscosReproduccion ALEATORIA/ Repeticion DE Reproduccion Pulse Prgm en el modo de paradaProgramar una canción Repita los pasos 2 y 3 para programar otrasGrabacion Basica Insercion DE Espacios SIN GrabarInserte la cinta que vaya a grabar en la platina GrabarPulse Tape Deck 1/2 para seleccionar la platina Pulse Sync DUB para iniciar la grabaciónPara detener el copiado Grabacion CON Edicion AI Inserte la cinta en la platinaPara detener la grabación Para borrar el programa de ediciónPulse CD EDIT/CHECK del control remoto para 10 Dé la vuelta a la cinta de la platina 2 y pulse wPara cambiar el programa de cada cara Pulse Dolby PRO Logic para seleccionar Normal Pulse de nuevo Manual Select para detener la señal de ruidoCompruebe lo siguiente Acerca de los canalesOtros Modos Dolby PRO Logic Pulse VIDEO/AUX y empiece a reproducir la Fuente de vídeoPulse Dolby PRO Logic Ajuste el volumen Pulse Power para desconectar la alimentaciónAjuste DEL Temporizador Por temporizadorPara cancelar el temporizador para dormir Grabacion CON TemporizadorTemporizador Pulse s una vez Pulse dos veces spara detener los dos números RestantesPara jugar con la demostración del juego Para reponer la demostración del juegoTomas VIDEO/AUX Toma CD Digital OUT OpticalToma SUB Woofer Pulse VIDEO/AUX Haga la reproducción en el equipo conectadoCuidados Y Mantenimiento GeneralidadesSeccion DEL Sintonizador Seccion DE LA PlatinaEspecificaciones Copyright Derechos DE AutorSignification des symboles graphiques AvertissementEnergie électrique Contrôler la chaîne et les accessoires Antenne extérieureEntretien Dommage nécessitant une réparationConnexions Connecter les enceintes avantConnecter les enceintes surround Connecter l’enceinte centralePositionnement DES Enceintes Telecommande Connexion D’UNE Antenne ExterieureMise EN Service DU Mode Economie D’ENERGIE Avant L’UTILISATIONFenêtre Clignotante Appuyer sur ECOAppuyer sur Clock tout de la télécommande Reglage DE L’HORLOGEAppuyer sur Enter ou a Reglages Audio Egaliseur GraphiqueSysteme Super T-BASS Systeme BBEAccord Manuel Memorisation DE StationsAccord PAR Numero DE Prereglage Appuyer sur f Down ou g UP pour sélectionner une stationOperations DE Base Appuyer sur c pour démarrer la lecturePour sélectionner une platine de lecture Pour mettre le compteur àSélection d’une plage avec la télécommande Mise EN Place DE DisquesLecture DE Disques Pour contrôler le temps restantAppuyer sur Prgm en mode arrêt Lecture ProgrammeeLecture ALEATOIRE/REPETEE Enregistrement DE Base Insertion D’ESPACES BlancsInsérer la cassette à enregistrer dans la platine Veut enregistrerAppuyer sur Tape Deck 1/2 pour sélectionner La platine Appuyer sur Sync DUB pour démarrer l’enregistrementPour arrêter la duplication Insérer la cassette dans la platine Pour arrêter l’enregistrementPour effacer le programme du montage Pour contrôler l’ordre des numéros des plages programméesEnregistrement Avec Montage Programme Pour changer le programme de chaque faceAppuyer sur Dolby PRO Logic pour sélectionner Normal Régler le niveau sonore des enceintes centrale Et surroundContrôler les points suivants Au sujet des canauxAutres Modes Dolby PRO Logic Appuyer sur VIDEO/AUX et mettre la source vidéo En lectureAppuyer sur Dolby PRO Logic Régler le volume Appuyer sur Power pour mettre l’appareil hors TensionReglage DE LA Minuterie Préparer la sourceEnregistrement Commande PAR Minuterie Pour annuler la minuterie d’arrêtAppuyer une fois sur s Utilisation du jeu demoPour réinitialiser le jeu demo Pour désactiver la démonstration ou le jeu, appuyer sur aPrises VIDEO/AUX Prise CD Digital OUT OpticalPrise SUB Woofer Soins ET Entretien GeneralitesPartie Tuner Partie MagnetocassetteDroits D’AUTEUR

NSX-HMT26, CX-NHMT25, NSX-HMT25 specifications

The Aiwa NSX-HMT25, CX-NHMT25, and NSX-HMT26 are solid entries in the realm of consumer audio equipment, showcasing Aiwa's commitment to quality sound and innovative technology. These compact stereo systems are designed for those who appreciate fidelity in sound without compromising on style or functionality.

One of the most notable features of these models is their robust sound output. Each system boasts a powerful amplifier that ensures clear, dynamic audio reproduction across different genres of music. Whether it’s the pulsating bass from electronic tracks or the nuanced highs of classical compositions, users can expect an impressive audio experience.

The NSX-HMT25 and NSX-HMT26 come equipped with a dual cassette deck, allowing for the convenient playback and recording of cassette tapes. This feature appeals to those who cherish the nostalgia of tape and wish to preserve their old recordings. In addition to cassette playback, both systems support CD playback, accommodating a diverse range of media formats. The CX-NHMT25 model enhances this versatility by incorporating a digital tuner, enabling access to a wide array of FM and AM radio stations.

These systems also feature advanced equalization options, allowing users to tailor sound profiles to their preferences. With preset equalizer settings and manual adjustments, audiophiles can customize sound output or select the ideal setting for different listening environments.

Another significant characteristic is the user-friendly interface, which includes an intuitive remote control. This design allows for easy navigation and control over the playback options from a distance, enhancing the overall user experience. The sleek and modern appearance of these stereo systems makes them an appealing addition to nearly any living space.

Connectivity is equally vital, and the Aiwa systems deliver in this aspect as well. They offer multiple audio input options, including auxiliary inputs for connecting external devices like smartphones or MP3 players. This ensures that users can easily integrate their personal music collections with the system.

In summary, the Aiwa NSX-HMT25, CX-NHMT25, and NSX-HMT26 stand out as versatile, high-quality audio solutions. With their solid sound performance, diverse media playback capabilities, customizable sound settings, and modern design, these stereo systems cater to both casual listeners and serious audiophiles alike, making them a noteworthy choice in home audio entertainment.