Cisco Systems EPC3208 manual Protect the Product from Lightning, Battery Safety, Battery Disposal

Page 12

IMPORTANT SAFETY INSTRUCTIONS

Protect the Product from Lightning

In addition to disconnecting the AC power from the wall outlet, disconnect the signal inputs.

Verify the Power Source from the On/Off Power Light

When the on/off power light is not illuminated, the apparatus may still be connected to the power source. The light may go out when the apparatus is turned off, regardless of whether it is still plugged into an AC power source.

Eliminate AC Mains Overloads

WARNING: Avoid electric shock and fire hazard! Do not overload AC mains, outlets, extension cords, or integral convenience receptacles. For products that require battery power or other power sources to operate them, refer to the operating instructions for those products.

Handling Disposable Batteries

This product may contain a rechargeable Lithium-Ion battery to provide stand-by operation in the event of an AC power failure.

Heed the following warning, follow the Battery Safety and Battery Disposal instructions below, and see the instructions later in this guide for handling, replacing, and disposing of the battery.

WARNING: There is danger of explosion if the battery is mishandled or incorrectly replaced. Replace only with the same type of battery. Do not disassemble it or attempt to recharge it outside the system. Do not crush, puncture, dispose of in fire, short the external contacts, or expose to water or other liquids. Dispose of the battery in accordance with local regulations and instructions from your service provider.

Battery Safety

Insert batteries correctly. There may be a risk of explosion if the batteries are incorrectly inserted.

Do not attempt to recharge ‘disposable’ or ‘non-reusable’ batteries.

Please follow instructions provided for charging ‘rechargeable’ batteries.

Replace batteries with the same or equivalent type that we recommend.

Do not expose batteries to excessive heat (such as sunlight or fire).

Do not expose batteries to temperatures above 100°C (212°F).

Battery Disposal

The batteries may contain substances that could be harmful to the environment.

Recycle or dispose of batteries in accordance with the battery manufacturer’s instructions and local/national disposal and recycling regulations.

vi

4027620 Rev A

Image 12
Contents Page Page Please Read Trademark Acknowledgments Publication DisclaimerSoftware and Firmware Use Copyright Page Mitteilung für CATV-Techniker Aviso a los instaladores de sistemas CatvPage Contents Customer Information Power Source Warning Ground the ProductVerify the Power Source from the On/Off Power Light Battery SafetyBattery Disposal Protect the Product from LightningProtect the Product When Moving It Provide Ventilation and Select a LocationTelephone Equipment Notice Viii Rev a Important Safety Instructions United States FCC Compliance Declaration of ConformityCanada EMI Regulation RF Exposure StatementsCanada AustraliaPage Rev a Xiii CE Compliance CEModem/EMTA Page Xvii About This Guide IntroductionPurpose AudienceChapter This ChapterIntroduction High-Speed DataDigital Voice ConnectionsManagement Software and DocumentationWhats In the Carton? Front Panel Description Introducing the Docsis Cable Modem Back Panel Description Page Installing the Docsis Cable Modem Installation Preparations What Are the System Requirements for Internet Service?What Are the Requirements for Telephone Service? What Types of Service Accounts Do I Need? Telephone Wiring RequirementsTelephone Device Types Dialing RequirementsHigh-Speed Internet Access Account Where Is the Best Location for My Cable Modem? Install the Battery OptionalTelephone Service Installing the Battery Close the battery compartment doorHow Do I Mount the Cable Modem on a Wall? Optional Select an Appropriate Place to Mount the Cable ModemEquipment Needed Position the Cable ModemLocation and Dimensions of the Wall-Mounting Slots Mounting the Cable Modem on a Wall Install the Cable Modem Connect Devices to the Cable ModemConnect the Cable Modem Install the Cable Modem Installing the Docsis Cable Modem Operation of Front Panel Indicators Operation of Front Panel Indicators Rev a Normal Operations AC Power Applied Front Panel LED Status Indicators During Normal ConditionsSpecial Conditions Page Maintaining the Battery Location of the Battery Battery Maintenance Charging the BatteryRemoving and Replacing the Battery Using the Cable Modem Without a Battery Troubleshooting the Docsis Cable Modem Frequently Asked Questions How Do I Configure TCP/IP Protocol?Configuring TCP/IP on Macintosh Systems How Do I Renew the IP Address on My PC? How Do I Arrange for Installation? What if I Dont Subscribe to Cable TV?How Does the Cable Modem Connect to My Computer? Can I Watch TV and Surf the Internet at the Same Time?Can I Use my Existing Phone Number with the Cable Modem? How Many Telephones Can I Connect?Common Troubleshooting Issues Dont understand the front panel status indicatorsThere is no dial tone when I lift the handset Cable Modem does not register an Ethernet connectionTroubleshooting the Docsis Cable Modem Tips for Improved Performance Page Customer Information Customer Support If You Have QuestionsAustralia Page Index Index