Cisco Systems DPC3208, EPC3208 manual Operation of Front Panel Indicators

Page 45

3 Chapter 3

Operation of Front Panel

Indicators

Introduction

This section describes the behavior of the front panel indicators when the cable modem is first powered up, during normal operations, and in special conditions.

In This Chapter

Initial Power Up, Calibration, and Registration (AC Power

applied)

22

Normal Operations (AC Power Applied)

24

Special Conditions

25

4027620 Rev A

21

Page 44 Page 46
Image 45
Page 44 Page 46
Contents
Page Page Please Read Trademark Acknowledgments Publication DisclaimerSoftware and Firmware Use Copyright Page Aviso a los instaladores de sistemas Catv Mitteilung für CATV-TechnikerPage Contents Customer Information Ground the Product Power Source WarningBattery Safety Verify the Power Source from the On/Off Power LightBattery Disposal Protect the Product from LightningProtect the Product When Moving It Provide Ventilation and Select a LocationTelephone Equipment Notice Viii Rev a Important Safety Instructions Declaration of Conformity United States FCC ComplianceCanada EMI Regulation RF Exposure StatementsAustralia CanadaPage Rev a Xiii CE Compliance CEModem/EMTA Page Xvii Introduction About This GuidePurpose AudienceThis Chapter ChapterHigh-Speed Data IntroductionDigital Voice ConnectionsSoftware and Documentation ManagementWhats In the Carton? Front Panel Description Introducing the Docsis Cable Modem Back Panel Description Page Installing the Docsis Cable Modem Installation Preparations What Are the System Requirements for Internet Service?What Are the Requirements for Telephone Service? Telephone Wiring Requirements What Types of Service Accounts Do I Need?Telephone Device Types Dialing RequirementsHigh-Speed Internet Access Account Where Is the Best Location for My Cable Modem? Install the Battery OptionalTelephone Service Close the battery compartment door Installing the BatterySelect an Appropriate Place to Mount the Cable Modem How Do I Mount the Cable Modem on a Wall? OptionalEquipment Needed Position the Cable ModemLocation and Dimensions of the Wall-Mounting Slots Mounting the Cable Modem on a Wall Install the Cable Modem Connect Devices to the Cable ModemConnect the Cable Modem Install the Cable Modem Installing the Docsis Cable Modem Operation of Front Panel Indicators Operation of Front Panel Indicators Rev a Front Panel LED Status Indicators During Normal Conditions Normal Operations AC Power AppliedSpecial Conditions Page Maintaining the Battery Location of the Battery Battery Maintenance Charging the BatteryRemoving and Replacing the Battery Using the Cable Modem Without a Battery Troubleshooting the Docsis Cable Modem How Do I Configure TCP/IP Protocol? Frequently Asked QuestionsConfiguring TCP/IP on Macintosh Systems How Do I Renew the IP Address on My PC? What if I Dont Subscribe to Cable TV? How Do I Arrange for Installation?How Does the Cable Modem Connect to My Computer? Can I Watch TV and Surf the Internet at the Same Time?How Many Telephones Can I Connect? Can I Use my Existing Phone Number with the Cable Modem?Dont understand the front panel status indicators Common Troubleshooting IssuesThere is no dial tone when I lift the handset Cable Modem does not register an Ethernet connectionTroubleshooting the Docsis Cable Modem Tips for Improved Performance Page Customer Information If You Have Questions Customer SupportAustralia Page Index Index
Top Page Image Contents