Grandstream Networks GXW40XX Basic Operations, Understanding GXW Voice Prompts, Main Menu, 71-78

BASIC OPERATIONS

UNDERSTANDING GXW VOICE PROMPTS

GXW40XX has a built-in voice prompt menu for simple device configuration. To enter the voice prompt menu, press *** on the standard analog phone connected to any FXS port.

TABLE 5: DEFINITIONS OF THE GXW VOICE PROMPTS
	Menu	Voice Prompt		User’s Options
	Main Menu	“Enter a Menu Option”		Enter “*” for the next menu option
				Enter “#” to return to the main menu
				Enter 01 – 05, 07,10 - 17, 47, 86 or 99 Menu option
	01	“DHCP Mode”, “PPPoE		Enter ‘9’ to toggle the selection
		Mode ”or “Static IP Mode”		If user selects “Static IP Mode”, user need configure all the IP
				address information through menu 02 to 05. If user selects
				“Dynamic IP Mode”, the device will retrieve all IP address
				information from DHCP server automatically when user reboots
				the device.
	02	“IP Address “ + IP address		The current WAN IP address is announced
				Enter 12-digit new IP address if in Static IP Mode.
	03	“Subnet “ + IP address		Same as Menu option 02
	04	“Gateway “ + IP address		Same as Menu option 02
	05	“DNS Server “ + IP address		Same as Menu option 02
	07	Preferred Vocoder		Enter “9” to go to the next selection in the list:
				•	PCM U
				•	PCM A
				•	iLBC
				•	G-726
				•	G-723
				•	G-729
	10	“MAC Address”		Announces the Mac address of the unit.
	12	WAN Port Web Access		Enter “9” to toggle between enabled and disabled
	13	Firmware Server IP		Announces current Firmware Server IP address. Enter 12 digit
		Address		new IP address.
	14	Configuration Server IP		Announces current Config Server Path IP address. Enter 12 digit
		Address		new IP address.
	15	Upgrade Protocol		Upgrade protocol for firmware and configuration update. Enter
				“9” to toggle between TFTP and HTTP
	16	Firmware Version		Firmware version information.
	17	Firmware Upgrade		Firmware upgrade mode. Enter “9” to rotate among the following
				three options:
			1.		always check
				2. check when pre/suffix changes
			3.		never upgrade
	47	“Direct IP Calling”		Enter the target IP address to make a direct IP call, after dial
				tone. (See “Make a Direct IP Call”.)
	71-78	Phone calls between		Applies to GXW4004/GXW4008. User can make internal calls
		different ports of the same		between different ports inside the same GW even without being
		GW 400x		registered to SIP server. By dialing *** and 7x user can reach
				colleague connected to port “x”.
	701-724	Phone calls between		Applies to GXW4024. User can make internal calls between
		different ports of the same		different ports inside the same GW even without being registered
		GW4024		to SIP server. By dialing *** and 7xx		user can reach colleague
				connected to port “xx”.
	86	Voice Mail		Number of voice mails
	99	“RESET”		Enter “9” to reboot the device; or
	Grandstream Networks, Inc.		GXW40XX User Manual			Page 11 of 38
				Firmware 1.0.4.2		Last Updated: 06/2011