RAD Data comm MBE10-1D, MBE10-8D Introduction, Site Requirements and Prerequisites

Chapter 2

Installation

This chapter describes the basic installation procedures for the MBE unit, including:

•Site requirements and prerequisites

•Package contents

•Equipment needed

•Installation and setup.

	2.1 Introduction
	MBE is delivered completely assembled. For instructions on installation of a single
	unit or two units in a 19-inch rack refer to the Rack Mounting Kit for 19-inch Racks
	guide that comes with the RM kit.
	After installing the unit, see Chapter 3, Operation for operating instructions.
	In case a problem is encountered, refer to Chapter 4 for fault isolation and
	troubleshooting instructions.
Note
	Any adjustments, maintenance or repairs should be performed only by a skilled
	technician who is aware of the hazards involved.
	Always observe standard safety precautions during installation, operation, and
	maintenance of this product.

2.2 Site Requirements and Prerequisites

Inspect the equipment container before unpacking. Note and report evidence of damage immediately to your RAD distributor.

Install the MBE unit within 1.5m (5 ft) of a grounded AC outlet furnishing 240V (115V).

Allow at least 90 cm (36") of frontal clearance for operator access. Allow at least 10 cm (4") clearance at the rear of the unit for interface cable connections.

The ambient temperature should be regulated between 0° to 50°C

(32°F to 122°F) at a relative humidity of up to 90%, non-condensing.

	Site Requirements and Prerequisites	2-1
Order from: Cutter Networks	Ph:727-398-5252/Fax:727-397-9610	www.bestdatasource.com