RAD Data comm MBE10-8D, MBE10-1D Connecting the Line, Connecting the LAN, To connect the line

Chapter 2 Installation MBE Family Installation and Operation Manual

I O

POWER

AUI

100-230 VAC

TO V.35 LINE

Figure 2-5. MBE Rear Panel, V.35 Connector

I	O	POWER
		AUI

TO RS-232/V.24

I O

100-230 VAC

POWER AUI

100-230 VAC

LINK 2 RS-232/V.24

LINK 1 RS-232/V.24

Figure 2-6. MBE Rear Panel, V.24 Connector

Connecting the Line

A connector is provided to connect each interface to the communication link.

To connect the line:

•See Appendix A for LINK connector pin assignments. Note that the X.21 and V.36 connections are provided by adapter cables to the RS-530 (25-pin connector) on the MBE rear panel.

Interface cards are interchangeable. Consult your RAD dealer for details.

Connecting the LAN

To connect to the LAN:

•Use a standard AUI (15-pin, D-type), 10Base2 (BNC) or 10BaseT (RJ-45) connector, provided by RAD.

Caution To ensure compliance with electromagnetic compatibility (EMC) requirements, it is recommended that you only use shielded data cables with this product. Make sure that the shield is connected to the metallic hood of the cable connector.

For units with V.35 ports, in order to protect against electrostatic discharge (ESD) into the port, use a connector with an overlapping hood that completely covers the pin connection.

2-8 Installation and Setup

Order from: Cutter Networks Ph:727-398-5252/Fax:727-397-9610 www.bestdatasource.com