Sony SRX-R105, SRX- R110 Connecting the Projector, Connecting with HD-SDI Equipment, 19 GB

Connecting the Projector

When you connect the projector, make sure to:

•Turn off all equipment before making any connections.

•Use the proper cables for each connection.

•Insert the cable plugs firmly; loose connections may increase noise and reduce performance of picture signals. When pulling out a cable, be sure to pull it out from the plug, not the cable itself.

•When installing the optional input board, consult with the Sony dealer.

Refer also to the instruction manuals of the equipment to be connected.

Connecting with HD-SDI Equipment

Attach the optional LKRI-002 HD-SDI (4:2:2) input board to the input board attachment part, and connect the HDCAM recorder/player.

Connecting with Component/Video GBR Equipment

Attach the optional LKRI-001 analog input board to the input board attachment part on the projector, and connect with a DVD recorder/player or analog video equipment equipped with the component output, or an high-definition equipment equipped with a video GBR connector.

Left side

R(Pr/Cr)	G(Y/Y) B(Pb/Cb)	HD	VD
r)	b)	HD	VD

INTER LOCK ETHERNET RS232C

R/Pr / G/Y / B/Pb connectors

Component cable, etc (not supplied)

Chapter 2 Preparations

Left side

INTER LOCK ETHERNET RS232C

IN OUT

INOUT

IN connector

to component output/ video GBR

Betacam, DVD recorder/player, etc.

Note

HD-SDI connecting cable (not supplyed)

to HD-SDI output

HDCAM recorder/player, etc.

When connecting to the output of HD component equipment, set “Signal Mode” of “Input Source” in the PICTURE CONTROL window to “Y/Pb/Pr,” and when connecting to the output of HD video GBR equipment, set to “RGB.”

For details, see page 26.

Connecting the Projector

19 GB