COLOR/FRAME Window, Signal Adjust, Color, 27 GB

Signal Adjust

Adjusts the picture quality of the input signal.

Clicking increases the setting value, and decreases it.

Clicking the RESET button resets all the settings to the factory preset values.

Contrast: Adjusts the picture contrast. The higher the setting, the greater the contrast.

Brightness: Adjusts the picture brightness. The higher the setting, the brighter the picture.

Color: Adjusts the color intensity. The higher the setting, the greater the intensity.

Sharpness: Adjusts the picture sharpness. The higher the setting, the sharper the picture. The lower the setting, the softer the picture.

COLOR/FRAME Window

The COLOR/FRAME window is used to adjust the input signal.

When the screen mode is set to “dual-screen” or “quad- screen,” the items can be independently adjusted for each input channel displayed on the screen.

Color

Adjusts the items so that you can obtain precise color reproduction.

If the color of an image is not correct, check the setting of “Color Space” first.

Select the setting from the drop-down list displayed by

clicking .

Color Space: Selects the color gamut.

709:Select when projecting a normal high-definition signal or RGB signal.

DCDM: Select when projecting a special source such as a movie.

CIEXYZ: This item is for future use.

Color Temp (temperature): Selects the color temperature from among “DCI W/P,” “6500,” “CUSTOM1,” “CUSTOM2,” “CUSTOM3” and “CUSTOM4.” “DCI W/P” is preset in CUSTOM1 to 4 settings in the factory.

“6500” is recommended for a normal high-definition signal or RGB signal. Set this item to “DCI W/P” to project a movie source.

Gamma: Selects a gamma correction curve from among “2.6,” “2.2” and “1.8.”

The smaller the value, the brighter the image. Select the setting depending on the signal source. “2.2” is recommended to project a normal high-definition signal or RGB signal.

Chapter 4 Adjustments and Settings Using the SRX Controller

COLOR/FRAME Window