Overview
Precautions
On safety
•Operate the unit on 200 – 240 V AC, 50/60 Hz (SRX- R110), or 100 – 240 V AC, 50/60 Hz
•Should any liquid or solid object fall into the cabinet, unplug the unit and have it checked by qualified Sony personnel before operating it further.
•Unplug the unit from the wall outlet or set the power switch to the lower position if it is not to be used for several days.
•To disconnect the cord, pull it out by the plug. Never pull the cord itself.
•The wall outlet should be near the unit and easily accessible.
•The unit is not disconnected from the AC power source (mains) as long as it is connected to the wall outlet and the power switch is set to the upper position.
•Do not look into the lens while the lamp is on.
•Do not place your hand or objects near the ventilation holes. The air coming out is hot.
•Have at least four people carry and handle the projector, to avoid accidents or injury.
•Avoid using an extension cord with a low voltage limit, as it may cause
•To carry the projector, be sure to use the carrying handles. Do not hold other parts of the projector, especially the lens, nor catch your finger between the handle, floor, and the projector.
•Do not catch your finger between the unit and surface of the floor when moving the projector installed on the floor.
•Be careful not to catch your finger in the cooling fan.
On installation
•Allow adequate air circulation to prevent internal heat
may block the ventilation holes. Leave space of more than 100 cm (39 3/8 inches) between the wall and the
Chapter 1
projector. Be aware that room heat rises to the ceiling; check that the temperature near the installation location is not excessive.
•Install the projector on the floor or hang it from the ceiling. Any other installation causes a malfunction such as color irregularity or a shorten lamp life.
•Do not install the unit in a location near heat sources such as radiators or air ducts, or in a place subject to direct sunlight, excessive dust or humidity, mechanical vibration or shock.
•To avoid moisture condensation, do not install the unit in a location where the temperature may rise rapidly.
On illumination
•To obtain the best picture, the front of the screen should not be exposed to direct lighting or sunlight.
•
•Cover any windows that face the screen with opaque draperies.
•It is desirable to install the projector in a room where floor and walls are not of
On preventing internal heat build-up
After turning off the power, the cooling fan runs for about 10 minutes while the STATUS LAMP indicator flashes in green.
Caution
The projector is equipped with ventilation holes (intake) at the front, upper side and right side, and ventilation holes (exhaust) at the rear and upper side.
Do not block or place anything near these holes, or internal heat
Chapter 1 Overview
Precautions
5GB