Chapter 4 Adjustments and Settings Using the SRX Controller
Frame Adjust
Adjusts the horizontal size and the position of the picture.
Clicking increases the setting value, and decreases it.
Clicking the RESET button resets all the settings of “Frame Adjust” to the
Dot Phase: Adjusts the phase of the SXRD panels and the input signal. Adjusts the value to obtain the clearest picture.
H Size: Adjusts the horizontal size of the picture according to the input signal. As the setting value increases, the horizontal size of the picture becomes larger.
H Shift: Adjusts the horizontal position of the picture. As the setting value increases, the picture moves to the right. As the value decreases, the picture moves to the left.
V Shift: Adjusts the vertical position of the picture. As the setting value increases, the picture moves up. As the value decreases, the picture moves down.
Notes
•Adjustment of “Dot Phase” and “H Size” is available for computer signal input only.
•If the position of the picture is not adjusted correctly, noise may appear in the blank portion of the screen. This is not a malfunction of the projector. Adjust the picture position correctly with “Frame Adjust.”
INSTALLATION Window
The INSTALLATION window is used to adjust the projected picture, change the lamp output, etc.
LENS CONTROL
Adjusts the projected picture on the screen.
Zoom
enlarges the picture size, and reduces the picture size.
Focus
on a forward picture. Clicking focuses on a picture further back.
Shift
Clicking moves the picture upward. Clicking moves it downward.
PROGRESSIVE DISPLAY MODE
Normally, click the Off radio button.
Click the On radio button when four HD images with 2048 (1920) × 1080 pixels are input from four
LAMP POWER
Adjusts the lamp power output. You can reduce the lamp power to 93%, 86%, 79%, 72%, 65%, 58% or 51%. The brightness of the projected image will be darker, but power consumption can be reduced and this increases the lamp life. Clicking the 100% radio button allows you to obtain the brightest projection image.
Note
Switching the lamp output frequently may reduce the lamp life. Use of the defined lamp output is recommended.
GB 28
INSTALLATION Window