Belkin 5000HQ user manual KVM-over-IP Device Network tab

Management

Table of Contents sections 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21

8..6 Targets

The targets you created appear in the “Targets” list.

You can choose to display all targets or just unassigned targets (default), or targets belonging to a target set. Select the desired option from the “Show Targets” drop-down menu.

You must associate the targets with the relevant IP device or with the port numbers on the KVM switch to which they are physically connected.

To associate the targets:

1.From the “Targets” list, double-click the target connected to port #1

of the KVM switch. The target assigns to port #1 of the “Ports” section. Alternatively, drag and drop the target to the correct port number.

2.Repeat the above step for all targets connected. Ensure the right target assigns to the correctly numbered port.

To remove a target from a port:

Double-click the target in the “Ports” section. The target name moves to the “Target” section and is now unassigned.

Note! Deleting a target removes its association with the KVM port number.

8..7 Network tab

In the “Network” tab, you configure and modify network parameters of the IP device.

Click the “Network” tab. The following appears.

Figure 56 KVM-over-IP Device – Network tab

Interface I displays the IP address of the KVM-over-IP device as discovered by the OmniView IP 5000HQ Manager system. You can change this address here.

Enter IP address, subnet mask, and default gateway for the network adapter, as given by your network administrator.

In “TCP Ports”, type three ports (from 800 and up to 65535). By default the port numbers are 900, 901, and 902. These default ports are suitable for the majority of installations.

OmniView IP 5000 HQ 40