ADTRAN MP-118 manual Assigning an IP Address to the MediaPack, Assigning an IP Address using BootP

MP-11x & Microsoft Office Communications Server 2007

3.2Assigning an IP Address to the MediaPack

If the gateway's default IP address (refer to Table 3-1)doesn't correspond to the network in which Office Communications Server 2007 is installed, you can assign a different IP address to the gateway, using one of the following methods:

„BootP (refer to Section 3.2.1 on page 14)

„Command Line Interface (CLI) using the RS-232 interface (refer to Section 3.2.2 on page 15)

„Gateway's HTTP-based Embedded Web Server (refer to Section 3.2.3 on page 16)

„DHCP (refer to the gateway's User’s Manual)

Table 3-1: Gateway Default Networking Parameters

Network Parameter	Default Value
IP address	10.1.10.11
Default subnet mask	255.255.0.0
Default gateway IP address	0.0.0.0

You can use the hardware reset button to restore the gateway's networking parameters to their factory default values (refer to Section 6.2 on page 40).

3.2.1Assigning an IP Address using BootP

You can use AudioCodes' Bootstrap Protocol (BootP) or any third-party BootP application to assign an IP address to the gateway.

¾To assign an IP address using BootP, take these 3 steps:

1.Open the BootP application.

2.Add a new client by performing the following (for AudioCodes BootP Server application):

a.From the Services menu, choose Clients; the Client Configuration dialog box appears.

b.Add a client configuration for the gateway that you want to initialize, by clicking the Add

New Client button.

c.Enter the necessary fields (i.e., gateway's MAC address and desired IP address), and then click OK.

Quick Installation Guide 14 Document #: LTRT-26301