2323232323 | 23 |
Video Board
To remove the video board, first remove the main board (see Main Board on page 21), and then perform the following steps:
1. Remove the five screws securing the video board.
A
Fig. 39 Location of screws securing video board.
2. Carefully separate the video board from the main board.
LCD Bezel
To remove the LCD bezel, first remove the LCD assembly (see LCD Assembly on page 16), and then perform the following steps:
1.Remove the six screw covers on the LCD bezel (one in each corner and two on either side of the webcam).
2.Remove the six screws that became accessible after removing the covers.
3.Carefully pry open the LCD bezel.
Inverter Board
To remove the inverter board, first remove the LCD bezel (see LCD Bezel on page 23), and then do the following:
1. Disconnect the cables from the inverter board.
Fig. 40 Location of inverter board.
Packard Bell EasyNote SL Disassembly Manual