Initio I/O HIGHWAY manual MS-DOS/Windows 3.1x Driver Installation

18

MS-DOS/Windows 3.1x Driver Installation

Installing the Initio ASPI drivers to an existing Windows 3.1x system

The ASPI for Windows 3.1x drivers are found on the INI-9XXXU/9XXXUW DVR DSK 1. It is important that the SCSI bus hardware, and operating system are installed correctly before proceeding further. If you need help installing Windows 3.1x, please refer to the Microsoft Windows manual before proceeding.

1Turn on host system and boot into MS-DOS and Windows 3.1x operating system.

2 Insert the INI-9XXXU/9XXXUW DRIVER DISK 1 into your floppy drive.

3Use your installed mouse or the appropriate key strokes to select RUN… from the Windows PROGRAM MANAGER. Execute the following steps:

•Type A:\SETUP <ENTER>. A series of screens will guide you through the installation of the ASPI for Windows device drivers.

•Choose CONTINUE to continue the installation sequence.

•Choose CONTINUE to accept the Host Adapter selection.

4Two installation options are available:

•Choose EXPRESS INSTALL to install both the DOS ASPI drivers and the Windows 32-bit Disk Access drivers. Use this option if you are unfamiliar with configuring a DOS or Windows manually.

•Choose CUSTOM INSTALL to select DOS ASPI drivers or the Windows 32-bit Disk Access drivers manually. Use this option only if you are familiar with configuring a DOS or Windows PC manually

5Follow the on-screen directions and/or options to continue the installation.

•Choose CONTINUE to accept the default directory or enter the full directory where you want ASPI drivers installed.

•Choose CONTINUE after all the files have been copied and installed to your system.

•Select YES to make the required changes to your system’s CONFIG.SYS and SYSTEM.INI configuration files.

•Once the SETUP COMPLETE screen is displayed, choose CONTINUE.

6Last minute changes to this User’s Manual will be displayed in the README.TXT file that is shown. To exit the README.TXT file, use your installed mouse or the appropri- ate key strokes to select FILE, then EXIT from the Note Pad FILE MENU.

7To complete the installation and activate the device driver, exit from your Windows 3.1x session and reboot the system by pressing <CTRL> + <ALT> + <DEL>.

initio®