36
Novell NetWare Driver Installation
6Select installation type. <ENTER>
7Enter server name when prompted <ENTER>
At this point the boot files will be copied to the hard drive.
8After the files are finished being copied you may encounter the following message:
Install found the following hardware but found More than one driver supporting this hardware
PCI.XXXX.XXXX.XXXX.XXXX.XX
Press <Enter> for a list of drivers to choose From or <F3> to continue without selecting
Press <F3> to continue. Repeat if this screen is shown again.
9A screen listing the drivers will be displayed. INI9100 will be listed as the selected driver. This completes loading the Host Adapter Driver, Follow the
This will load the HAM driver. If a DSK driver is required or an updated HAM driver is needed it is recommended that you complete the installation and use NetWare’s INSTALL utility to update/change the driver.
Adding the Initio driver to an existing IntraNetWare sys- tem
1To begin the installation you will need to change the directory to the location of the server and initialize the network server, e.g.,
Type CD \ NWSERVER <ENTER> Type SERVER <ENTER>
2At the NetWare prompt, Type LOAD INSTALL <ENTER>.
3Select Driver Options from the window by highlighting it using the UP or DOWN ARROW keys, press <ENTER>
•Select Configure disk and storage device drivers from the window by high lighting it using the UP or DOWN ARROW keys, press <ENTER>
4 Highlight Discover and load additional drivers and press <ENTER>
5NetWare will load INI9100.HAM modify the STRATUP.NCF file to reflect the new changes.