Energy Tech Laboratories EDP70 manual Load

Page 48

RESERVE F xx.x Hz

AB xxx V BC xxx V CA xxx V

press once

LOAD F xx.x Hz

A xxx V B xxx V C xxxV

press once

LOAD F xx.x Hz

AB xxx V BC xxx V CA xxxV

press once

LOAD

A xxx A B xxx A C xxx A

press once

LOAD

A x% B x% C x%

press once

LOAD P.F. 0.99

P = 80kW s = 80kVA

press once

TIME ON INVERTER xxg: xxh: xxm: xxs

press once

Displays the frequency and the phase-phase voltage of the reserve supply.

Displays the frequency and phase-neutral voltage supplied to the load.

Displays the frequency and phase-phase voltage supplied to the load.

Displays the current supplied to the load.

Displays the load capacity percentage of the UPS rated value.

Displays the Peak Factor of the load current.

Displays the total time the load has been supplied by the inverter since the machine was last switched off.

page 48 --MI00/10056 rev.1--05/2001

Image 48

Contents EDP70 Plus Important Safety Instructions Read Before Installing ALL CASES, Seek Medical Attention Immediately Contents Figures Block diagram IntroductionSummary of the manual Summary of the equipment24kVA Standard Configuration Functions 480VOperational modes 24/36kVA Ratings10 --MI00/10056 rev.1--05/2001 Safety General safetySymbols Electrical precautions Battery precautionsBattery safety equipment Installation Mechanical characteristicsStorage ALL Measurements are Millimeters and Inches NR4 16 --MI00/10056 rev.1--05/2001 Battery Cabinet Drawing for 24/36kVA Ratings 18 --MI00/10056 rev.1--05/2001 Battery Cabinet Drawing for 50/80kVA Ratings 20 --MI00/10056 rev.1--05/2001 Installation Recommended wire sizes Supply Output Reserve Supply UPS Type Ventilation = 2770 - - - ∙ e 0.125 h Tk / T0 Tr TkConnection OutputUninterruptible Power System No Unauthorized Operation MI00/10056 rev.1--05/2001-- Table of T& B’s cat.no.s for terminals and crimp tools Electrical connectionsBattery Compartment 24 12/18/24kVAOutput, Reserve, Input Reserve Ground Primary Input Output External Batteries 36 24/30/36kVA Observe Polarities and Orientations RS232 Female EDP70 Plus 50/80kVA 36 --MI00/10056 rev.1--05/2001 QS1 QS2 QS3 QS4 QS5 Signal connections Emergency Power OffBattery charge inhibited Thermostick connector 50/80kVA onlyDisplay indicators ControlsUser Controls Control Panel LCDStart UP Maintenance Bypass Installing the EPOSHUT-DOWN MI00/10056 rev.1--05/2001-- Visual and Audible Alarms Silencing Audible AlarmMimic Liquid Crystal DisplayDisplay Page Headings System NormalBattery Test Weekly Power History Down to Access Load Time on Reserve xxg xxh xxm xxs Inverter Load Abnormal operating mode messages System AlarmStop DUE to Overload RECTIFIER/BATTERY Alarms Message Condition Inverter Alarms Message Condition LOAD/RESERVE Alarms Message Condition Power History Power History MatrixBattery Test Battery Autonomy TestResetting data loss manually MI00/10056 rev.1--05/2001-- Computer Interface 11.1 AS400Remote Alarms 11.2 RS23213.1 EDP70 PLUS/24/18/12 Battery Installation/Start-up Batteries= EDP70 PLUS/24/18/12 Internal Battery Shelves 13.2 EDP70 PLUS/24/18/12 Optional Battery CubicleMaintenance and Spare Parts 13.3 EDP70 Plus above 20kVA Battery Installation/Start-up13.4 EDP70 Plus above 20kVA Battery Cubicle EDP70 Plus System LOG