Energy Tech Laboratories EDP70 manual Inverter Alarms Message Condition

Page 55

INVERTER ALARMS

MESSAGE	CONDITION
NOT CALIBRATED	FAULT

PCB SUPPLY FAULT	FAULT

OUT OF SYNC	WARNING

DESATURATION	FAULT

OVER TEMPERATURE	FAULT

BYPASS SWITCH CLOSED	FAULT

SHUTDOWN IMMINENT	WARNING

DC VOLTAGE HIGH	FAULT

DC VOLTAGE LOW	WARNING

INVERTER NOT RUNNING	FAULT

INVERTER INHIBITED	FAULT

INVERTER BLOCKED	FAULT

INVERTER VOLTS HIGH	FAULT

INVERTER VOLTS LOW	FAULT

OVERLOAD	WARNING

STOP DUE TO OVERLOAD	FAULT

CURRENT LIMIT	WARNING

INV.ST. SWITCH FAULT	FAULT

INV.FREQ.OUT RANG. 8%	FAULT

INV. FEEDBACK FAULT	FAULT

VERIFYING INV. FREQ.	-

VERIFYING BATT. CONT.	-

INV.FREQ.OUT 1%	FAULT

MI00/10056 rev.1--05/2001-- page 55

Image 55

Contents EDP70 Plus Important Safety Instructions Read Before Installing ALL CASES, Seek Medical Attention Immediately Contents Figures Summary of the equipment Block diagramIntroduction Summary of the manual24kVA Standard Configuration 480V Functions24/36kVA Ratings Operational modes10 --MI00/10056 rev.1--05/2001 General safety SafetySymbols Battery precautions Electrical precautionsBattery safety equipment Mechanical characteristics InstallationStorage ALL Measurements are Millimeters and Inches NR4 16 --MI00/10056 rev.1--05/2001 Battery Cabinet Drawing for 24/36kVA Ratings 18 --MI00/10056 rev.1--05/2001 Battery Cabinet Drawing for 50/80kVA Ratings 20 --MI00/10056 rev.1--05/2001 Installation Recommended wire sizes Supply Output Reserve Supply UPS Type = 2770 - - - ∙ e 0.125 h Tk / T0 Tr Tk VentilationOutput ConnectionUninterruptible Power System No Unauthorized Operation MI00/10056 rev.1--05/2001-- Electrical connections Table of T& B’s cat.no.s for terminals and crimp tools24 12/18/24kVA Battery CompartmentOutput, Reserve, Input Reserve Ground Primary Input Output External Batteries 36 24/30/36kVA Observe Polarities and Orientations RS232 Female EDP70 Plus 50/80kVA 36 --MI00/10056 rev.1--05/2001 QS1 QS2 QS3 QS4 QS5 Thermostick connector 50/80kVA only Signal connectionsEmergency Power Off Battery charge inhibitedControls Display indicatorsUser Controls LCD Control PanelStart UP Installing the EPO Maintenance BypassSHUT-DOWN MI00/10056 rev.1--05/2001-- Liquid Crystal Display Visual and Audible AlarmsSilencing Audible Alarm MimicSystem Normal Display Page HeadingsBattery Test Weekly Power History Down to Access Load Time on Reserve xxg xxh xxm xxs Inverter Load System Alarm Abnormal operating mode messagesStop DUE to Overload RECTIFIER/BATTERY Alarms Message Condition Inverter Alarms Message Condition LOAD/RESERVE Alarms Message Condition Power History Matrix Power HistoryBattery Autonomy Test Battery TestResetting data loss manually MI00/10056 rev.1--05/2001-- 11.1 AS400 Computer Interface11.2 RS232 Remote AlarmsBatteries 13.1 EDP70 PLUS/24/18/12 Battery Installation/Start-up13.2 EDP70 PLUS/24/18/12 Optional Battery Cubicle = EDP70 PLUS/24/18/12 Internal Battery Shelves13.3 EDP70 Plus above 20kVA Battery Installation/Start-up Maintenance and Spare Parts13.4 EDP70 Plus above 20kVA Battery Cubicle EDP70 Plus System LOG