Dell R805 Expansion-Card Risers, Removing Expansion-Card Riser, Replacing Expansion-Card Riser

4.Reinstall the cooling shrouds. See Cooling Shrouds.

5.Reinstall the expansion-card riser 2. See Replacing Expansion-Card Riser 2.

6.Reinstall the expansion cards from riser 2. See Installing an Expansion Card.

7.If applicable, reinstall the SAS controller daughter card. See Installing a SAS Controller Daughter Card.

8.Close the system. See Closing the System.

Expansion-Card Risers

Removing Expansion-Card Riser 1

CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that came with the product.

NOTE: You must remove all expansion cards from the expansion-card riser before removing the riser from the system.

1.Turn off the system, including any attached peripherals, and disconnect the system from the electrical outlet.

2.Open the system. See Opening the System.

3.Disconnect all cables connected to the expansion card.

4.Remove all expansion cards from the expansion-card riser. See Removing an Expansion Card.

5.Press the tab at the bottom of the riser to release the board from the card slot and lift expansion-card riser 1 off of the mounting pins and out of the system. See Figure 3-17.

Replacing Expansion-Card Riser 1

Aligning the two pin collars over the mounting pins on the system board, gently lower the center riser board until the board connector is firmly seated into the system board socket. See Figure 3-17.

Figure 3-17. Removing and Replacing Expansion-Card Riser 1

1 pin collars (2) 2 release tab

3expansion-card riser 1 4 mounting pins (2)

5system board socket