Installing the Sideplane Board
1.Insert the sideplane board into sideplane slots along the left wall of the chassis and lower the sideplane board so that the pin collars connect with the two pins on the system board. Press the sideplane down until sideplane connector is fully seated into the system board connector. See Figure
2.Reattach the control panel cable to the sideplane board.
3.Replace the storage controller daughter card. See Installing a SAS Controller Daughter Card.
4.Close the system. See Closing the System.
Figure 3-29. Sideplane Removal and Installation
1 | sideplane | 2 | control panel connector |
|
|
|
|
|
|
3 | control panel cable | 4 | sideplane release tab (2) |
|
|
|
|
|
|
5 | pin collar (2) | 6 | chassis pin (2) |
|
7 | sideplane connector | 8 | system board |
|
|
|
|
|
|
9 | SAS controller daughter card | 10 | SAS controller daughter card release handle |
|
|
|
|
|
|
11 | SAS controller daughter card socket |
|
|
|
|
|
|
|
|
|
|
|
|
|
SAS/SATA Backplane Board
Removing the SAS/SATA Backplane Board
CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that came with the product.
1.Turn off the system and attached peripherals, and disconnect the system from the electrical outlet.
2.Open the system. See Opening the System.
3.If present, disconnect the optical drive power cable from the SAS/SATA backplane board. See Removing the Optical Drive from the System.
4.Open the
5.Remove the storage controller daughter card. See Removing a SAS Controller Daughter Card.
6.Disconnect the SAS cable from the backplane connector.